Verdeboy
In the Trades
- Messages
- 2,041
- Reaction score
- 6
- Points
- 0
I haven't done one of these before. I had to cut off the corroded bolts holding the bearing housing in place. The housing came off with what was left of the rubber "pillow". The bearing itself, with its brass bushing, is fused to the axle. Anyone know where I can get a pillow block bearing puller that will work for a swamp cooler axle? I guess I can try to cut it off, but I'd rather try to pull it off. Also, if it's such a tight fit, how do I slide the new one over the axle? I would hate to have to pound on it with a hammer.
Attachments
Last edited: