Eltorro
New Member
- Messages
- 21
- Reaction score
- 0
- Points
- 0
My house was built in early 70's..No plastic..I'm putting in a new sink and had to remove the wall pipe that goes into the wall..I needed a longer one.
It seem where it goes in behind the wall into the plumbing there was some type of gasket as pieces of it fell out when I removed the pipe..I can tell with my finger that there is a ridge in there where a gasket could fit..
What would I call it at Home Depot or should I just load it up with silicone?
It is a 1 1/2 " waste pipe..
Pic of what I am seeing is at http://home.comcast.net/~richandellen/DSC00843.JPG
Dick.
It seem where it goes in behind the wall into the plumbing there was some type of gasket as pieces of it fell out when I removed the pipe..I can tell with my finger that there is a ridge in there where a gasket could fit..
What would I call it at Home Depot or should I just load it up with silicone?
It is a 1 1/2 " waste pipe..
Pic of what I am seeing is at http://home.comcast.net/~richandellen/DSC00843.JPG
Dick.