(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 6 of 6

Thread: Tank is about 2 inches from the wall

  1. #1

    Default Tank is about 2 inches from the wall

    We just bought and installed a Kohler Cimmaron. We replaced an old American Standard that was probably put there when the house was built in the early 60s. Anyway, the tank sits about 2 to 3 inches from the wall and I am bothered that someone might lean back on it and if not break it off, crack the bowl. Do I need to be concerned about this? Should I put a block or something behind it?

  2. #2
    Forum Admin, Expert Plumber Terry's Avatar
    Join Date
    Aug 2004
    Location
    Bothell, Washington
    Posts
    14,208
    Blog Entries
    1

    Default

    Tanks don't normally touch the wall.

    Most toilets are designed to be about 1" from the wall.
    But they could also touch the wall or be 3" or more inches away,
    depending on the "rough-in" of the current drain location

    That measurement is from the wall to the center of the drain.
    Last edited by Terry; 04-17-2007 at 03:40 PM.

  3. #3
    Engineer maddog's Avatar
    Join Date
    Aug 2006
    Location
    near San Jose, CA.
    Posts
    131

    Default

    I also have a Cimarron installed with a 12" rough-in. And there is about 2 inches between the tank and the wall. I never thought that someone might use it as a recliner. It was actually a positive thing when painting the bathroom. I didn't have to pull the tank as I was able to use a mini-roller to paint behind the tank!

    -dog

  4. #4

    Default

    You know maddog, someone should come up with a design for a reclining toilet. It's about the only place in my house where I can be alone and relax.



    Thanks Terry for answering.

  5. #5
    DIY Junior Member Barney1's Avatar
    Join Date
    Apr 2007
    Location
    Ohio
    Posts
    13

    Default

    Maddog,

    I have a Cadet3 with a 12 rough in. I too have a 2 gap behind the toilet. Im thinking about getting a 14 and that should push it back the 2 that I need. What do you think?

  6. #6
    Retired Defense Industry Engineer jadnashua's Avatar
    Join Date
    Sep 2004
    Location
    New England
    Posts
    21,434

    Default

    Measure from the bolts that connect the toilet to the flange straight back to the finished wall (not to the baseboard or trim). This is the magic dimmension. That is what you actual rough-in is. Reading the specs of a toilet will tell you how far the toilet sits from the wall when installed on a standard flange install. The combination of the spec sheet and the actual dimmensions of your particular installation will tell you whether the toilet will fit, and how far away it will end up once installed.
    Jim DeBruycker
    Important note - I'm not a pro
    Retired Defense Industry Engineer; Schluter 2.5-day Workshop Completed 2013, 2014

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •