remodelerrose
New Member
- Messages
- 1
- Reaction score
- 0
- Points
- 0
Hi... How would you install a tongue and groove ceiling on a ceiling that has been stripped down to the joises?Any help would be appericated. Thanks... Bernie
tongue and groove ceiling
- Thread starter remodelerrose
- Start date
Users who are viewing this thread
Jimbo
Plumber
Well, the answer literally is that you put it up one board at a time, toe nailing the tonques. What specific question do you have?>
Sponsor
Paid Advertisement
TedL
New Member
Paint or stain before applying.
Apply perpindicular to the joists.
Apply perpindicular to the joists.
R
Rancher
Guest
Ok I did one of these, so I'm an expert... OK at least I know how I would re-do it.
Is there insulation, vapor barrior in place?
I would use Tyvek as the vapor barrior, I didn't use one just blew in insulation, I get a lot of ceiling creaks... kinda like the house is going to fall down.
Yes paint or stain first.
If you have the time buy the T&G and then rick it and let shrink all it can. Bevel the ends if you are going more than one board length.
Stagger the joints, it looks beter if it is random.
Snap some chalk lines if you have a large ceiling, so when you get to the opposite wall you are even.
Hope this helps.
Rancher
Is there insulation, vapor barrior in place?
I would use Tyvek as the vapor barrior, I didn't use one just blew in insulation, I get a lot of ceiling creaks... kinda like the house is going to fall down.
Yes paint or stain first.
If you have the time buy the T&G and then rick it and let shrink all it can. Bevel the ends if you are going more than one board length.
Stagger the joints, it looks beter if it is random.
Snap some chalk lines if you have a large ceiling, so when you get to the opposite wall you are even.
Hope this helps.
Rancher
Similar threads
