(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 3 of 3

Thread: Chalk Another One Up For This Forum

  1. #1

    Default Chalk Another One Up For This Forum

    One of my customers called me to fix a leaky tub faucet. She said a plumber had tried to fix it a few weeks earlier, but could not remove the frozen, stripped bib seat. He put a new washer on and said it wouldn't last long, and that she'll need to replace the whole shower manifold for $500.

    Well, the washer lasted a couple of weeks, and hot water was pouring out at about a gallon a minute when I got there. I couldn't get that seat out either, so I sprayed some PB Blaster in there and waited 20 minutes. I tapped on my seat wrench to get a good bite and was surprised to feel the seat turning out.

    I never heard of PB Blaster before this website, so I owe it all to you guys.
    Last edited by Verdeboy; 04-06-2007 at 09:05 PM.

  2. #2
    DIY scratch-pad engineer leejosepho's Avatar
    Join Date
    Nov 2006
    Location
    200 miles south of Little Rock
    Posts
    2,474

    Default

    I would suspect the hot water and your tapping did at least as much as the PB, so be careful about thinking it did/does *all* the loosening!

  3. #3

    Default

    I did plenty of tapping and turning before I used the PB Blaster, and all I did was further strip the inside of the seat!!

    I was thinking about wedging a drill bit in the seat and slowly backing it out with my cordless if that didn't work. Are there any "real" seat extractors on the market? Maybe a small nipple extractor would work if the PB Blaster fails.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •