(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 6 of 6

Thread: Cordless optical mouse going bad

Hybrid View

  1. #1

    Default Cordless optical mouse going bad

    I have a fairly expensive Logitech cordless optical mouse that is going haywire. It's not under warranty that I know of. With the low-tech mouse, you just took it apart and cleaned out the dust that had collected on the ball, and you were good to go. This one has a circuit board inside.

    I guess it's time to get a new one unless anyone has any suggestions.

  2. #2

    Default

    I've got one of those, too.

    Check the batteries, then make sure the receiver (from USB port) is close enough to the mouse to communicate.

    Good luck

  3. #3

    Default

    Try relinking to the receiver. And, that the receiver is not close to a monitor.

  4. #4
    Plumbing Designer FloridaOrange's Avatar
    Join Date
    Dec 2005
    Location
    SW Florida
    Posts
    1,317

    Default

    If all else fails get a laser mouse next time. Won't help you if it goes bad but batteries last longer and the mouse is very accurate.

    I also keep a regular old corded ball mouse in the closet just in case.
    Matt
    Semi-professional plumbing designer
    Enjoying life in SW Florida

  5. #5
    DIY Member D.Smith's Avatar
    Join Date
    Feb 2007
    Location
    Georgia
    Posts
    63

    Default

    http://www.newegg.com/Product/Produc...82E16826104015


    99.00 mouse onsale for 89.99 plus a 20.00 rebate.



    use this promo code for additional 15.00 off

    EMC403DREVO


    Drops it to about 55 plus some change

  6. #6

    Default

    Well, I relocated the receiver part and pushed in the USB connection, and it seems to be fine now. I did bounce the little mousey off the wall a couple times out of frustration, thinking it was already toast. But it didn't seem to affect it.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •