When doing a job where PEX is being used and you need to use a 90* instead of just bending the pex (tight spot), how confident do you feel about this fitting or do you try to avoid them.
If you try to avoid them is it because you are concerned about the fitting failing or the cost?
There is a job going on in my neighborhood where there are A LOT of Uponor ProPex fittings being used in ceiling and joist bays. I'm curious as to how folks feel about this sort of thing verses the home-run methods, etc.
If you try to avoid them is it because you are concerned about the fitting failing or the cost?
There is a job going on in my neighborhood where there are A LOT of Uponor ProPex fittings being used in ceiling and joist bays. I'm curious as to how folks feel about this sort of thing verses the home-run methods, etc.