Goodiemobb
New Member
- Messages
- 1
- Reaction score
- 0
- Points
- 0
I recently installed a new 1 hp deep well jet pump, it was set at 30/50 psi. It took a while to get a prime but once it was primed the gauge(new) would not go over 30 - 35 which means the pump would not shut off. I have checked the pressure in the pressure tank with a tire gauge and it read 30 psi. which I was told it should be 28 - 32, So that shouldn't be the problem. Also, when I did shut the pump down, it did still maintain the pressure. Any ideas what the problem is? Thanks in advance.
PS.
PS.