raybigto
New Member
Hi Everyone,
This will be my first post here. This forum is awesome. Here goes.... In removing the old tub at home, I found the tub drain connection "glued" to the p-trap. The photo shows the threading on the p-trap wasn't used to connect the brass/crome pipe. It was "glue" instead. The p-trap is also cemented to the edge of the home's foundation. They had to break some foundation to make from for it, and then mortared it in place. Removing the 90 degree elbow would require me to break some motar (foundation) to make room. How can I remove that glue to remove the crome/brass piece? As seen in photo I broke the piece (covered with tape) not knowing it was glued. Has anyone every encounted this situation? Any suggestions appreciated!
Raymond
This will be my first post here. This forum is awesome. Here goes.... In removing the old tub at home, I found the tub drain connection "glued" to the p-trap. The photo shows the threading on the p-trap wasn't used to connect the brass/crome pipe. It was "glue" instead. The p-trap is also cemented to the edge of the home's foundation. They had to break some foundation to make from for it, and then mortared it in place. Removing the 90 degree elbow would require me to break some motar (foundation) to make room. How can I remove that glue to remove the crome/brass piece? As seen in photo I broke the piece (covered with tape) not knowing it was glued. Has anyone every encounted this situation? Any suggestions appreciated!
Raymond
Attachments
Last edited: