wacked pipe

Users who are viewing this thread

Scott99

New Member
Messages
33
Reaction score
0
Points
0
okay, so I get my new therm mixer soldered in, out of the top port up about 6in a valve. no pipe yet on the output side. the valve has the plastic rough in depth extension install. the mixer has threaded ports.

I'm on a ladder working on shower head fitting and while getting down I wack the plastic extension pretty hard with my knee.... I'm sure it flexed the pipe to some point, and now I'm worried that I stressed or fractured the joints and may get a leak. Its been under pressure for two days and so far so good.

Is this something I should be concerned with and should redo that section, or just consider it stress tested and move on??
 

Scott99

New Member
Messages
33
Reaction score
0
Points
0
thanks, those comments help put my mind at ease. three days, so far so good...
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks