Call a service tech. There is a sensor that detects the flame, to keep the gas flowing, and it is not working for what ever reason. Just a guess from here though but that is what it sounds like.
|
|
|
last night a toilet overflowed on the 2nd floor causing water to run down into the laundry/furnace room . . . since then then furnace will try three times to ignite and stop. It's a carrier weather maker 8000.
I've turned the gas and power off to the unit and let it sit for over 5 minutes, when I turn it back on, the (glow light) turns red and the four gas burners kick on, but only for a few seconds . . . it repeats the process 3 times and stops.
It's now only 50 in my house and we're in single digits outside . . . PLEASE ANY HELP!!
Call a service tech. There is a sensor that detects the flame, to keep the gas flowing, and it is not working for what ever reason. Just a guess from here though but that is what it sounds like.
Make sure everything is dried up. Look for a small metal rod that is in the flame on one of the burners. Once located, get some fine sand cloth or paper and clean this rod then retry. Good luck.
Bookmarks