(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: H20Man; Keyword(s):

Search: Search took 0.13 seconds.

  1. Thread: Gas dryer Vent

    by H20Man
    Replies
    8
    Views
    1,749

    By adjustable elbow do you mean metal flexible...

    By adjustable elbow do you mean metal flexible pipe?
  2. Replies
    201
    Views
    48,079

    This is only true for the el cheapo tankless...

    This is only true for the el cheapo tankless heaters.

    All the good ones adjust their BTU output based on the temp of the incoming water. You can even set the temp of the outgoing water to a...
  3. Thread: Gas dryer Vent

    by H20Man
    Replies
    8
    Views
    1,749

    The hose between the dryer and the rigid vent...

    The hose between the dryer and the rigid vent connection is going to have to be flexible, right? I don't see how you could connect rigid vent directly to your dryer unless you screwed the dryer to...
  4. Replies
    7
    Views
    2,581

    There's nothing wrong with mine. I'm just doing...

    There's nothing wrong with mine. I'm just doing it for preventative reasons like the manual suggests.
  5. Replies
    7
    Views
    2,581

    What about the pump and hoses? Just rig...

    What about the pump and hoses? Just rig something up from parts from Lowe's/HomerDepot? Most pumps you see there are like effluent pumps and are quite expensive....
    Any suggestions?
  6. Replies
    7
    Views
    2,581

    Flushing tankless water heater w/ vinegar

    Where do you get a 5 gal bucket of vinegar? Sams club or something?

    What about a good inexpensive pump to use for the flush? Do you just rig out some vinyl hose or whatever to the pump? I...
  7. Replies
    9
    Views
    19,631

    :) Gives me an idea anyway. :)

    :) Gives me an idea anyway. :)
  8. Replies
    201
    Views
    48,079

    Yeah, you should have bought a Rinnai. 8 gpm. ...

    Yeah, you should have bought a Rinnai. 8 gpm.

    Also, you're missing the point on the tankless heaters. Yeah, they are more efficient since you don't have to keep a tank hot all the time. But...
  9. Replies
    9
    Views
    19,631

    Ok, I'll try that. How tight should it be? Hand...

    Ok, I'll try that. How tight should it be? Hand tight? Light wrench pressure? Medium wrench pressure?
  10. Replies
    9
    Views
    19,631

    In this case, I'm trying to put a copper 3/4"...

    In this case, I'm trying to put a copper 3/4" male threaded adapter into one of the "isolator valves" made by webstone for tankless water heaters.
    http://www.webstonevalves.com/isolatorexp.html
    ...
  11. Replies
    9
    Views
    19,631

    Pipe thread compound? Can't stop a leak!

    I've never had good success when connecting brass fittings together using pipe thread compound (rectorseal Tplus2 if it matters). I thoroughly coat both the male and female threads, then tighten...
  12. Thread: P-trap code?

    by H20Man
    Replies
    6
    Views
    2,488

    P-trap code?

    In order to meet code for a p-trap, how long can the horizontal run be after the trap before entering the waste/vent stack?

    Can there be any slope downwards in the horizontal run at all between...
Results 1 to 12 of 12