Search:

Update: Well is running, and water, and is crystal clear.
Thank you all, for the tips and info.

Thanks, found the lead plug-in, on their Manual, will call them tomorrow.

Lead plug-in has three wires going in, and has two metal leads on the other end.
All three wires were broken going in to...

What about a 230V relay system?

Is there anything else, I might Need?

The well pump and well pump motor, looked good.

Do you know where I can find this electrical connector that plugs into the Gould Bruiser motor?

The arrestor type they carry here locally.

Need advice on setting up some type of Cut Off Switch in the mechanical room of home.
The cut off switch, would trigger the well pump to turn off, when some type of water sensor detects water in...

I'm trying my best, and with the help of you all in forum, this well will be up and running very soon.

The bad weather the other factor, not a simple project,
:D
Thank you God!

18809
All...

torque arrestors ? any differences?

Today, the weather is beautiful, sun is shining and some fresh air.

We can't wait to get this all fixed and back running again.

As removed from well casing; photos showing exactly the well pump, and pump wires at pump, and the electrical splice connection for the well pump. no arrestor.
The upper casing of well pump was...

Done with a couple of the fabricated tools made from scrap metal I found lying around.

How do I go in lowering the pitiless?

I'm finding hard to decide on the configuration of pumps and and their specs.

Nice well water depth setup ... (looks like a new well), and clean job work to boot.
Made some Jigs (fabricated tools), but lacking one more tool to get started.

thanks all for your assistance...

What would be the recommended pump height for a 1 HP 10-15 GPM well pump?

Good advice. I will lower the pitless adapter.

Dug out water line at well head, water line was measured at 32 inches From pitless adapter To ground level.
The pitless adapter is the clamp around the 4.5" PVC pipe type. There's roughly, about 16...

Safety First, will be first on my replacing the well pump list.
Its been really cold with lows in the single digits, and highs in the 30's and 40's, with ice and snow on the ground. Weather started...

I have some scrap metal and pipe available, and metal tools and welder.
To hold pipe; will be fabbing a pipe clamp holder with a couple of wood block. I have a variety of clamps to play with here.

This fab tool set; it hold a section of drop pipe as its getting pulled up, and this Fab tool set, is used for the disassembly of a section of pipe from leaning over and for support?

I don't understand, new management or lighter product?

what pumps have worked for all you?

I really appreciate all your comments, and assistance, it making realize I'm not ready to tackle this yet.

A friend of mine had a Red Lion Submersible Well pump installed last year, he seemed to be happy with the pump and he did mention they use Franklin Motors. Are Red Lion pumps of good quality?

Question: I called around, for an Up Z Dazy . No one has any. Any suggestions on pulling up well pipe?

When I met with the well man 7 years ago. He mentioned for this area, he had set plenty of wells, and at 120 to 140 deep well casing, there was plenty of water for house hold and lawn.
My thinking,...