Search:

thanks to all..krow, you were right, all i needed to do was to take handle off and rotate 180 deg (to six o'clock position)...now works fine...THANKS

OK, guys (and gals)....just moved into new house..built in 2000.
one of the baths has a moen single control shower....silver backplate with teardrop shape, clear plastic knob with gray trim, with H...

As usual, good ideas...
1. I'll try root x (or maybe copper sulphate crystals?)
2. I'll put cleanout in 4" stack in basement
3. This winter, I'll take tree out.... it is only 12" in diameter,...

Need advice. 35 yr old house in Atlanta. 2 story with basement. Lot slopes to rear of house with french doors from basement to back lawn. Basement toilet backs up. 4" cast iron drain hanging from...

I think I asked this same question on this forum and was told that is the way the Bosch is designed....I verified it with the manufacturer (because I doubted the responses----even though these guys...

Thanks for the reply. I called Blanco and talked to a tech rep----who was quite helpful and is sending me a cartridge and "o" rings for free.
I went online and found a schematic. I took it apart...

by "spout", you mean the faucet body coming up out of sink, right?
To remove what I call the spout (the piece with hose that comes out of body where cartridge is located), do I have to turn off...

Blanco Harvest faucet, model 157-080-st with pull out spray.
The body coming out of sink (where ceramic cartridge is located) is stiff to rotate. Can I take control lever off, unscrew large ring,...

I agree Redwood....thanks

no, flow is fine to seal because with top of column off, I turned the water on to "flush" the fluidmaster column and the water pressure and volume are fine.... I have copper pipes and the shutoff...

I have a standard toilet about 30 yrs old...it has fluidmaster "guts" that are about 5 years old. the toilet works ok, but it takes 65 sec to fill tank after flushing. I turned off water, took top...

Ok...don't anybody chastise me because I have never done this, but a car detailer told me if you add about 6 oz of kerosene to a 5 gal bucket of soapy water the water will "sheet" off. I've never...

Ok guys, Took off the compression ball valve. Ball will not rotate when handle is rotated. It is a Apollo International, with yellow plastic over handle. 600 cwp. CII----whatever that means. It...

No, line was not frozen. the low was 25 but it got up to 60 yesterday. When I got home about 7 pm it would still not allow water to pass. The cold side worked fine (even that morning) and cold...

I have ball valves on with compression fittings, so will be easy to change out. I thought I had read somewhere that hot would freeze faster and at lower temps, but I can promise you the "stem" is...

I have an outside hot/cold faucet made by having two ball valves tied together at their exits to form one hose bib. The ball valves are exposed to the elements. These are commercial brass type...

no ideas? thanks

Set the new water heater on a pressure treated box made out of 2x6's and even if you get a couple of inches of water in the future, you won't have problem with pilot light....just a thought.

I have a moen 7100 filtered (pure touch) water faucet at sink with low volume and pressure. I have changed the filter. There is no aerator on it (doesn't come with one). Regular faucet has good...

thanks jadnashua. I only blew out the drain line and when I put the 90 psi on it, it was not "completely sealed off so the air shot through without a 90 psi buildup.....

eric, I will post what the tech says when he comes out....

I got home tonite and turned it on again. it is not spraying water. yes, the water is turned on. This means the pump is probably bad. but it is just a little to coincidental that the pump would...

lou, there is no wire. the part that makes the ice is 1 foot above the bin...this is an under counter ice machine. it will not make any ice now.
the scotsman continually makes ice since the bin...

eric, thanks. the drain is "relatively" clear. I poured about a gallon down it and it drained a little slow, but did drain. Problem is it is not making any ice.
I can't imagine what happened...

thanks. It is a separate under the counter icemaker. there is no "wire" lever for ice flow. Probably need to call repair man. I read once if the drain is not completely open to allow quick...