(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: rcfunk; Keyword(s):

Search: Search took 0.14 seconds.

  1. Thanks I was afraid of that. The air handler...

    Thanks I was afraid of that. The air handler mentioned above went to an older 83 model GE heat pump, 6 seer I beleive.

    The Trane mentioned above is a 10 seer.

    Any recommendations on a simple...
  2. Trane XE1000 matching air handler/heater question

    I have a Trane XE1000 1.5 TON outside heat pump, model TWR018C100A1.

    I want to see about using this outside heatpump on the following indoor air handler located in my attic:

    General Electric...
  3. Replies
    14
    Views
    2,116

    I see what you are saying.... thanks.... then I...

    I see what you are saying.... thanks.... then I have 3/4" pipe going out the wall to the well. Don't think I'll be able to change that at this point.
  4. Replies
    14
    Views
    2,116

    Thanks, I went and checked, the skinniest point...

    Thanks, I went and checked, the skinniest point of pipe in the pic (almost mid way between the bottom elbow and the T pipe going to pressue tank) measures 1 inch exactly.
  5. Replies
    14
    Views
    2,116

    Thanks for the reply. I'm not even sure where...

    Thanks for the reply. I'm not even sure where the line is that goes down to the submersed pump. The previous home owner didn't mark the pump location on the ground. I may have to try to contact...
  6. Replies
    14
    Views
    2,116

    Ok, here is my setup... let me know what you...

    Ok, here is my setup... let me know what you think.
    The main line is coming in on the right side of the pic.
    The pressue gauge is reading 46-47psi or so with no water being used at that time in...
  7. Replies
    14
    Views
    2,116

    Ok, I'm not real sure if there is a check valve,...

    Ok, I'm not real sure if there is a check valve, but if it is where I can see it, it would be between the pipe from the outside and the switch box. I may be able to attach a picture if that would...
  8. Replies
    14
    Views
    2,116

    Thanks for the replies, you guys are a great...

    Thanks for the replies, you guys are a great resource.

    As far as the pump, I know it is a submersible pump in the well. I found what looks to be some kind of control box on the basement wall (the...
  9. Replies
    14
    Views
    2,116

    General Water Pressure Question

    I have a Well-X-Trol WX-202 and a Square D 9013FSG 30/50 switch. Basically what is happening is the pump will click and cut on properly when pressure gague hits 30psi on the switch, but when water...
Results 1 to 9 of 9