(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: JOE1934; Keyword(s):

Search: Search took 0.13 seconds.

  1. Replies
    0
    Views
    1,049

    Looking for 2 stage honeywell thermostat

    I have radiant floor heat (domestic H/W) and hot water baseboard(boiler).I'm looking for a Honeywell thermostat that would work the two heat stages (1st stage would be radiant heat,2 stage the BB...
  2. Thread: Air Eliminator

    by JOE1934
    Replies
    1
    Views
    1,884

    Air Eliminator

    I'm installing a Weil-McLAIN CGA-3,IT has--- cast iron sections with built-in Air Separator.Should I still install an Air Eliminator or is the Air separator all I need (I believe they are the same...
  3. Replies
    2
    Views
    2,215

    Pex-copper rings -stainless steel clamp

    Which would be more durable in the long run, copper or stainless steel clamp.Can you use these clamps on different tubing.EX-Wirsbo has own connecting system,special tools(really expensive for...
  4. Replies
    3
    Views
    1,946

    Securing in S/F base board

    I am wondering about securing it in the base board. If I use PEX will the expansion (PEX suppose to expand when hot), be to much inside the S/F BB
  5. Replies
    3
    Views
    1,946

    Pex or copper for return

    Which would be better, PEX or copper in the return of the slant-fin Base Board . I'm concerned about securing the PEX inside the S/F BB.Where or how do you secure it inside the BB.
  6. Replies
    5
    Views
    2,416

    Yes I agree with a mixing valve,you make a very...

    Yes I agree with a mixing valve,you make a very good point.My problem is that if I put BBHW on a wall I have to fill the whole wall (length-boss says so,won't look right-HA HA). The cost of dummy...
  7. Replies
    1
    Views
    1,723

    Pex and insulation

    If you use Pex for Base board hot water do you have to insulate it.
  8. Replies
    5
    Views
    2,416

    temp of hot water in Base Board HW

    I'm installing BBHW (slant-fin 30).I will have to connect low temp radiate floor heat to system to a new boiler.Could I have temp set at 150 degrees,yes I know I would have to have more feet of...
  9. Replies
    1
    Views
    2,590

    How to pick right size taco pump

    I'm going to have 3 separate pumps for 3 zones,BB hot water,gas. Do you establish a flow rate for each zone (f=Q/500 X 20) (http://www.taco-hvac.com/uploads/FileLibrary/SelectingCirculators.pdf). The...
  10. Replies
    5
    Views
    1,988

    I would be using Gas as the fuel.I have thought...

    I would be using Gas as the fuel.I have thought of using a domestic water heater but the temp output is way to low.I need temp of around 180 not 130-140.Any ideas of a water heater that has a high...
  11. Replies
    5
    Views
    1,988

    What size boiler

    I did 2 heat loss cal's and came up with 17,000 (tenant),38,000 (main apt).What size hot water boilers would be best size.Want conventional,cast iron will use with BB hot water heat. Where can I get...
Results 1 to 11 of 11