(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Biddle; Keyword(s):

Search: Search took 0.13 seconds.

  1. If I manage to get it out, does any company on...

    If I manage to get it out, does any company on the web sell just the piston and seat? The gray surface coating of the piston is now scratched up from me trying to get it out.
  2. Tried to remove the piston from the housing...

    Tried to remove the piston from the housing tonight. No luck. I placed the housing piston side down so that the piston was against a block of wood. I tapped on the back of the housing with a hard...
  3. The housing is brass. What could go wrong with a...

    The housing is brass. What could go wrong with a brass housing? Intuitively, I would think it is the piston assembly that is bad. Don't know how to get the piston out of the brass housing. I tried...
  4. I see on internet sites I can buy the Fleck 1650...

    I see on internet sites I can buy the Fleck 1650 assembly, which includes the piston for $34 or the 1650 value body for $8. Does any one sell just the piston assembly if the body is good? My problem...
  5. Thanks for all your help.

    Thanks for all your help.
  6. I understand. Thank you. I'll order one right...

    I understand. Thank you. I'll order one right away. Do you think the mismatch is what was causing squealing during the back wash as well as causing a slow brine draw?
  7. Injector is white. Throat is gray. Tank is 9"...

    Injector is white. Throat is gray. Tank is 9" diameter. When the back wash part of the cycle starts there is a high squealing sound until it moves on to the brine and slow rinse part of the cycle.
  8. What Causes the Brine Draw to be Very Slow in Water Softener?

    I have two water softeners plumbed in line with each other to remove iron. The brine draw by water softener #1 is very slow: a guess is that is takes about 30 minutes to draw a gallon of brine from...
  9. It's brass. I have another water softener setup...

    It's brass. I have another water softener setup that's plastic. Do recommend plastic or brass? Thanks.
  10. Must have been spacy yesterday. I looked at the...

    Must have been spacy yesterday. I looked at the control head today and understood exactly what you were telling me. I removed the brine piston assembly and am soaking it in Iron Out to see if I can...
  11. Not following you - we may be speaking about a different model

    There are no back nuts on the gray tube on the back side of the piston assembly. I don't know what you are referring to as an "injector block". The gray piston is encased in a brass assembly. I think...
  12. How do I remove the brine piston assembly at the control head of a Fleck 2510?

    Need a bit of help. The brine piston in my Fleck 2510 control head is stuck and won't move in or out. Is there any way to free it or should I replace the brine assembly? The piston is gray plastic...
  13. Thanks Akpsdvan and mialynette2003 for your...

    Thanks Akpsdvan and mialynette2003 for your response.

    Akpsdvan: Your message says "the 1650 brine system and brine valve stem is slow to close or there is something on the rubber seal at its...
  14. Need Some Help Please: Control Valve Doesn't Shut Off Brine Tank Refill

    While trying to determine why my Fleck 2510 control valve won't suck brine from the brine tank, I discovered that the brine tank refill line flows continuously. If it wasn't for the safety overflow...
Results 1 to 14 of 14