(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: jaegerilla; Keyword(s):

Search: Search took 0.12 seconds.

  1. Replies
    6
    Views
    466

    overload protector tests at less than one ohm in...

    overload protector tests at less than one ohm in both positions. apparently it is good. makes sense, since it's been doing it's job. next I will replace stationary switch with new one. ordered one...
  2. Replies
    6
    Views
    466

    aha... as I suspected... thermal overload...

    aha... as I suspected... thermal overload protector. stands to reason that it got smoked too.
    SO... will test it, but PROBLEM... if it's bad, is it from capacitor meltdown due to overly high...
  3. Replies
    6
    Views
    466

    oh, yeah... btw... long hard day... and as I...

    oh, yeah... btw... long hard day... and as I mentioned addled brain. backed pressure down to 48psi.... 2 below, not 2 above... yeeeesh.
  4. Replies
    6
    Views
    466

    thus far..

    ok... so... I understand the start capacitor, knew that before I replaced it. terminal board was obvious,... now understand stationary switch and rotating switch... still not sure what the round flat...
  5. Replies
    6
    Views
    466

    Thanks for the info, much appreciated, my dad set...

    Thanks for the info, much appreciated, my dad set the system up that way 26 years ago, I just go on what he taught me, and try to learn as much as possible from there. I read a little bit about...
  6. Replies
    6
    Views
    466

    no pressure from pump, help please!

    ok... sure to be a long post but here goes... I have a 2" x 50 foot well with shallow pump above ground (a.o.smith 48m2fc4c1, 3450 rpm, 1.5 HP, 230v) and bladderless tank. 50/70 pressure switch. I...
Results 1 to 6 of 6