Search:

I posted about my pipe replacement last week. Finally got over to Hajoca for the parts. Replaced the trap and the 90 (which came with a long enough pipe to hit the wall). Also scored some of that...

The PVC route will suffice. :D I looked at that closer, there is enough solder on there to build another Hoover Dam. :) The PVC route sounds perfect, I'll hit the plumbing place in the morning.

I cut the 90 off, at the joint was a piece that connected that to the main pipe. Apparently part of the pipe was damaged previously, as when I cut it part of the pipe between my cut and the wall...

That nut doesn't tighten there, in normal mode it's on the end of the 90 where the lip is.

I'm going to the store shortly, I'll see what they have, I might cut that out and solder a new section...

http://i2.photobucket.com/albums/y22/castu/House/pipe.jpg

If you look at the left side of the picture where that 90 degree turns down you'll see the crack - it's right above the black washer. I...

The house was built in 1915. (never again)

Could I resolder a replacement in? I have some soldering stuff from when I had to fix a few leaky copper joints in the mid 90s.

This morning the mrs dropped a contact lens down the sink again so I once again pulled the trap out. While reassembling it I noticed that the flange on the wall side is cracked about 1/3 of the way...