(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Tmbr2; Keyword(s):

Search: Search took 0.12 seconds.

  1. Replies
    2
    Views
    1,609

    It actually wasn't the cartridge, my kids had...

    It actually wasn't the cartridge, my kids had been moving the handle up and down really quick and I didn't think anything about it. Then when I pulled everything apart I noticed a chunk of rubber on...
  2. Thread: Point well help

    by Tmbr2
    Replies
    1
    Views
    739

    Point well help

    I haven't been on here since June of last year, asking about help with installing a point well. Well I used all the information that was given to me, and it worked out terrific. I was able to core...
  3. Replies
    2
    Views
    1,609

    No hot Water on Single Handle in Shower

    I've got a Kohler Single Handle valve in my guest bathroom, and the hot water will ONLY come on it the fully open position at 12 oclock. And then it is just a trickle at that. I have plenty of cold...
  4. Replies
    5
    Views
    886

    Ok, makes sense. That's why I'm in here to get...

    Ok, makes sense. That's why I'm in here to get advice from those who know. So what should I do instead? Just run it off of the actual jet pump or get a larger tank. If I were to run it off the...
  5. Replies
    5
    Views
    886

    Now that I have the point installed, I need to...

    Now that I have the point installed, I need to get the pump. I want to get a pump with a tank attached to it so I can tie into my existing spigots piping. I will be bypassing my water softener and...
  6. Replies
    5
    Views
    886

    Almost done with the point

    I originally posted questions in the irrigation section, and got a lot of help. But I've been reading more of the posts in this section and have gotten even more help. I've pounded the point down 7...
  7. Replies
    5
    Views
    2,638

    StevenB, I'm in the same boat as you are, I...

    StevenB, I'm in the same boat as you are, I started driving my point not to long ago and ran into problems with the sledge hammer like I found out on here. You can get a fence post driver from...
  8. Replies
    4
    Views
    1,545

    Speedbump, Quick question for you. ...

    Speedbump,

    Quick question for you. The hammer that you made, how much does it weigh. I bought a fence post driver, but after 5 solid hits on the pipe, it only drove it down about a 1/2...
  9. Replies
    5
    Views
    1,265

    What you may want to try, it's a bit cheaper, is...

    What you may want to try, it's a bit cheaper, is if you can get ahold of some Cat5 communications cable. Make sure it's Non-Plenum or PVC as it's called by some. It's got 4 pairs in it at 24 gauge....
  10. Replies
    4
    Views
    1,545

    alright, I'll try a fence post driver. I was...

    alright, I'll try a fence post driver. I was thinking of making one that would fit over the drive cap, but I may just change out the drive cap to a coupling that the fence post driver would fit...
  11. Replies
    4
    Views
    1,545

    Driving first point well need a little help

    Ok, I've been reading some of the other posts regarding point wells and how to get the best possible flow from them. It's a heck of a lot more information than I've found anywhere else, so anyone...
Results 1 to 11 of 11