(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: albertadave; Keyword(s):

Search: Search took 0.15 seconds.

  1. Replies
    10
    Views
    929

    I did a test today..I cut a 7" piece of copper...

    I did a test today..I cut a 7" piece of copper pipe in half, (From when I installed 3 new Watts, full port ball valves,to replace the old gate valve bypass setup before my softener) about a year ago....
  2. Replies
    10
    Views
    929

    Tom ,my pipes are 3/4"copper. What would you...

    Tom ,my pipes are 3/4"copper. What would you recommend for treating my iron situation.. 2..7 to 3.0 PPM, and my GPM is around 4....
  3. Replies
    10
    Views
    929

    The reason for the bubbles, I found out , has...

    The reason for the bubbles, I found out , has nothing to do with the water source.. "Nucleation points" are where the bubbles form. They can be caused by defects on the glass itself, or an improperly...
  4. Replies
    10
    Views
    929

    Thanks Gary.. The resin tank was spotless ,I...

    Thanks Gary.. The resin tank was spotless ,I think the existing rust in the pipes is probably the reason. Is their anyway to backwash or clean the pipes.
    Could you give me a rough idea of my salt...
  5. Replies
    10
    Views
    929

    SST-60.. Still have iron.

    I just re-bedded my resin tank with SST-60 .Cleaned the resin tank spotless, added water very slowly, and did a full regeneration. I don't have a fancy test kit, but my small Phenanthroline test,...
  6. Replies
    6
    Views
    1,029

    What's wrong here..

    Not to point out the obvious..."]http://passport2design.com/design-blunders-in-central-america/15951.
Results 1 to 6 of 6