Search:

thanks all, I guess it is time for a new one.
Charles

Water heater is a Rheem and 9 years old. Thing I do not under stand is why it on leaks once in a while. NOt leaking from any of the valves . I put a container under the valves so I know it is not...

I have a water heater that leaks once a day from around the bottom. It leaks maybe 1/4 of a cup.
I can not see where it is coming from. Anyone have an ideas?
Charles

Has anyone ever installed an Eljer Gibraltar bathtub and what do they think of it?
JIm

Thanks to all, THe tub is in stock at a box store , so contractor is charging 100% to travel 3/4 of a mile to pick it up. Does seem a bit high.
Jim

I am taking bids to remodel 2 bathrooms and the kitchen. Any thing the contractors supply, they double the price. LIke the bathtub cost $300 at a box store and they charge $600 , is this common...

Hate to butt in but I am running into the same problem, tying the (new) second sink into a 2.0 horizontal waste running about 6 feet from the first sink to a 3.0 waste(down to basement/vent thru the...

Jadnashua,
The 3.0 is a vent going vertical thru the roof and nothing drains into above the sink I am adding. It is waste going down.
Chuck

HJ,
What more do I need to cut in the waste for the second sink?
Thanks

I would like to add a second sink in a bath. The second sink will be between a sink and a 3 inch vertical waste/vent. The waste going from the sink to the 3.0 waste/vent is 2 inch. What kind of...

Have any of you used the fernco non-wax unit for setting a new toilet.
If this works it looks like it could be used when the flange is lower than it should be after tiling. Thanks
Chuck

I have a darker tan tub , toilet and sink which I would like to go white.
The sink and toilet are no problem but to swap out the tub to white and retile the suround for the tub the cost is quite...

Thanks for the info.
Chuck

The waste pipe is 3.0 inch and I believe the flange fits over the 3.0 inch. The waste pipe is located between 2 , 2x10 joist with about 1/2 clearance. Does not seem to be room to cut the pipe to...

I have had three new homes built and the plumber always cuts short the 12 inch dim. for the toilet. Any reason you plumbers couldn't make the 12 ruf in a little strong? Say by a quarter of an inch.

I had a new Heil furnace installed a couple of months ago and during start up the installer said that there would be some smoke for a couple of minutes.
Well there was some smoke and a burnt smell....

Thanks to all for your replies.
Kingnus

I have a master bath with a 78 inch long vanity and just one sink located at the right end of the vanity. The 2.0 waste line runs to the left inside the wall to a 4.0 dia pvc pipe about 85 inches...