Search:

Does this hold true for the temp mixing valve as well? Being that each head is controlled by a single volume control valve I don't think that they are the problem. However, all volume control valves...

Thanks hj

Moen 3600 valves, one for each head are 3/4" in/out. fed through a moen 3371 exect temp mixing valve 3/4" in/out. I doubt the valves are the problem. Perhaps the mixing valve is not up...

I have a shower setup with multiple heads. I can run any two heads ok, but when I open the third, the pressure drops to an unaceptable level. The piping is all new 3/4" copper, and the supply from...

I just finished wiring my new home from the ground up. I am having issues with lamps flickering at times very minor, other times more severe. I define minor as a half a second or less in duration,...

We have been living in temporary housing while doing a major remodel on our home. To be fair, it is more new construction than it is remodel.

The time is drawing near to get back into the home....

Thanks for the excellent reccomendation. I picked up a 1AC-A1-II and it is exactly what I was looking for. No false reports, and is discriminating enough to pickup the hot side of a lamp zip cord and...

[QUOTE=Billy_Bob;152453]Yes digital voltmeters are too sensitive. Ignore that reading.

As to finding the "hot", every connection to a 3-way switch would be the hot as it is switching the hot!
...

While poking around with a digital volt/ohm meter looking for the hot conductor in a three way switch circuit, I noticed a reading of 38 volts on the red conductor. I get the same reading at either...

I have an inspector complaining about my box make up, I would like a second, third fouth, etc opinion.

He wants no more than a quarter inch of sheathing left on the romex after the cable enters...

If I have a circuit with 14 guage wire and a 15 amp breaker, can I tee off or extend that circuit using 12 guage wire? It seems that as long as the breaker is sized at 15 amps, the smallest wire size...

I'm not familar with those, who makes them?

Thanks! Can you point me to a source for this connector rating information?

I'm installing a new 200A Service panel while remodeling. This unit has 42 slots, but there is no way that there are enough knockouts for even half that many cicuits. Does the NEC alow doubling or...

Imagine a nail being driven thru both cables. Don't think you want 120vac running thru your RG6. Seperate them.

Climate is mild, no frezzing issues, summer temps rarely exceed 95 degrees.

The possibility of a leak has me concerned as well. I'm not in the trade, so my experience with leaky water heaters has...

All good feedback, exactly what I was looking for. Thanks guys!

I have my architect looking into the weight issue.

MP Mark, do you happen to know the height dimension of the Rheem tank you're...

We are doing a complete rebuild on our home, and I'm looking for advice on what to use for water heating. The plans call for a Tankless unit in the attic, but after much research, I'm not sold on...