Search:

Any internet sources for this would be appreciated

I'm sure someone here can help me ... I'm looking for a brass 3/4 inch quick disconnect valve for my propane line to my generator. The type that you slide the outer sleeve back : plug in the male...

So, if the tank is pumped and the environmental conditions are consistent... is the vent config in the drawing correct enough to be functional? Another question... Does the outside clean-out act as...

The tank is pumped yearly, and being only a basement bath tank means it doesn't get used too often.

On the vent subject I should mention that the two vents are about 3 feet apart. This is a small...

- I have a basement bathroom with 2 sinks a toilet and a shower.
- The home has 2 septic systems so the basement setup has a dedicated septic system.
- When my sinks run the toilet bubbles and...

Hi all. what is the best pressure to charge a RO holding tank too?

nhmaster, I'm not sure I undertsand your response... Are you suggesting that I plumb it with copper only? If I could I would, the area it's going can not support that type of install. I'll also...

Can I use a faucet hose, 30" steel braided over rubber, to tie in my toe kick heater? Or is there some special type of hose or this ?

Yes, i do mean a Mono Flo tee. And thanks I thought I needed 2 but wasn't certain

I'm ready to install a toe kick heater. I believe I have all the parts I need I just have one last question. At the entry point of the loop I have a "dual directional tee" (sorry for not knowing...

No need to ask my question ... I just discovered I installed my mono flow T incorrectly ...

I'll take some shot tomorrow and post them. !!

To everyone that helped out out with my bathroom buildout... Thanks!! We're approved (with a nice compliment from the inspector on the neatness of the work) and everything is working perfectly!!! ...

I'm going to change my shower base drain to an ABS version... No risk!

Is there one that exsists? My shower base is PVC equiped but my waste lines are ABS and I dont have room for a fernco...

So it's not proper to vent before the trap? That's good info, and the reason for my pic and question...

The trap is below the drain. This setup is above the floor, the p-trap is below the floor between the joists.

Please bear in mind that the vent tube will be tied into the vent for the shower going through the roof.

Hi all, I'm ready to put down my shower base which is a one piece molded presloped tile ready deal. The manufacturer recommends a latex modified thin set as a base. I also understand that I'd want...

And Terry, I'd never have made it through this project without your experts!

I'm not a contractor and the ones near me wont sell to me ... :(
I need an online resource...

Does anyone know where I can order plastic to copper no-hub couplers? I've been to 5 big box depots and some of the smaller guys and nothing! I need the ones that allow for the differant outside...

All this being said, My intent is to demo the area... I'm going to vent to code in the rebuild. I was just curious how it would actually drain in this configuration ... mabe lucky?

The nearest vent is upstream and about 7 feet away...

So I have a tub/shower on the main floor of a ranch. It's 40 years old and during a remodel I've opened the ceiling below it (finished basement) The tub doesn't have a vent. Just the standard...