Search:

45, and it suppose to recognize when it needs a regen.

I'm back......had the water tested and it came back 1GPG which = hardness, correct? I checked the disrtib. tube o ring and the valve components, all were good. Raised the softness to 45, no regen. in...

update....I installed a new board and have the same results. I did a manual electronic check while house water was running, it showed the menu counting gallons, and also the main menu showed running...

Haven't checked that 'o' ring yet but someone suggested turning up the softness to max which I did, to 95, shouldn't the unit be regen. very often. I did a manual regen. and there was a salty taste...

ok, I think I follow you and I'll check that o ring. in the whes30 manual it's listed as# 1 on page 24, I would enclose picture but not having luck doing that. Thanks so much for your help.

I'm on private well and no chlorine is present, I assume by the 'o'ring you are refering to the large 'o' ring, 3-3/8"x 3-5/8" with the rotor and disc assembly.. There are two smaller o rings under...

Thanks all for your suggestions, I know it's not the' board'. As I stated before, if I disconnect the brine line to the venturi there is suction at the fitting and I can suck brine up, the discharge...

I have a whes30 water softener and have been trouble shooting it for a while as the 'softness' has vanished. I know the venturi is working as I disconnected the line from the fitting and there is a...