Search:

It actually wasn't the cartridge, my kids had been moving the handle up and down really quick and I didn't think anything about it. Then when I pulled everything apart I noticed a chunk of rubber on...

I haven't been on here since June of last year, asking about help with installing a point well. Well I used all the information that was given to me, and it worked out terrific. I was able to core...

I've got a Kohler Single Handle valve in my guest bathroom, and the hot water will ONLY come on it the fully open position at 12 oclock. And then it is just a trickle at that. I have plenty of cold...

Ok, makes sense. That's why I'm in here to get advice from those who know. So what should I do instead? Just run it off of the actual jet pump or get a larger tank. If I were to run it off the...

Now that I have the point installed, I need to get the pump. I want to get a pump with a tank attached to it so I can tie into my existing spigots piping. I will be bypassing my water softener and...

I originally posted questions in the irrigation section, and got a lot of help. But I've been reading more of the posts in this section and have gotten even more help. I've pounded the point down 7...

StevenB, I'm in the same boat as you are, I started driving my point not to long ago and ran into problems with the sledge hammer like I found out on here. You can get a fence post driver from...

Speedbump,

Quick question for you. The hammer that you made, how much does it weigh. I bought a fence post driver, but after 5 solid hits on the pipe, it only drove it down about a 1/2...

What you may want to try, it's a bit cheaper, is if you can get ahold of some Cat5 communications cable. Make sure it's Non-Plenum or PVC as it's called by some. It's got 4 pairs in it at 24 gauge....

alright, I'll try a fence post driver. I was thinking of making one that would fit over the drive cap, but I may just change out the drive cap to a coupling that the fence post driver would fit...

Ok, I've been reading some of the other posts regarding point wells and how to get the best possible flow from them. It's a heck of a lot more information than I've found anywhere else, so anyone...