(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: dlarrivee; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.15 seconds.

  1. Replies
    5
    Views
    717

    James, you're really onto something. Why don't...

    James, you're really onto something.

    Why don't they put labels on absolutely everything.

    And then warnings on them to.

    This is a FORK.

    Caution: Fork is sharp at one end
  2. Replies
    17
    Views
    3,815

    You're bringing up point loads when we were...

    You're bringing up point loads when we were looking at a load bearing wall.

    A point load would be a post supporting a beam, not an entire wall with studs every 16".

    John, you know your stuff...
  3. Replies
    17
    Views
    3,815

    What is a trim screw John? I'm glad you admit...

    What is a trim screw John?

    I'm glad you admit that you don't know, because it is blatantly obvious that you'd be in over your head on even a small framing job.

    I'm curious as to your...
  4. Replies
    17
    Views
    3,815

    You're really confusing a lot of terms here John....

    You're really confusing a lot of terms here John.

    There is no such thing as a ceiling "stud", you're talking either a joist or a rafter tie here. If the house is built with trusses for the roof,...
  5. Replies
    17
    Views
    3,815

    Sorry that you don't want to do any more work (I...

    Sorry that you don't want to do any more work (I know you already did some work on the joists).

    Is that seriously a splice on the right hand joist about 4' from the foundation wall?

    Your best...
  6. Don't mind HJ his knowledge in this department is...

    Don't mind HJ his knowledge in this department is 60 years out dated.
  7. Replies
    7
    Views
    548

    I consider this whole thing spam just based on...

    I consider this whole thing spam just based on the stupid choice of user name.
  8. I have no idea what it is, but you will always be...

    I have no idea what it is, but you will always be amazed at the crap sitting inside some piping.

    Continuous waste under kitchen sinks are always fun too.
  9. I can see why you'd rather not, but you're going...

    I can see why you'd rather not, but you're going to need to move the double wye downstream, so the vents can rise vertically inside that stud wall there.

    I know it means breaking more concrete,...
  10. Replies
    14
    Views
    3,297

    Don't use DELTA FL and XPS together. Frame...

    Don't use DELTA FL and XPS together.

    Frame after you finish the floor, it will be much better that way.

    You will need to tapcon the ply, it wont stay there floating perfectly without.
  11. Replies
    9
    Views
    823

    Access from below the concrete slab Jim? If...

    Access from below the concrete slab Jim?

    If you cannot find a plumber with some very specific tools you're going to be renting a jack hammer and taking up that floor.
  12. I wasn't aware we were arctic here...

    I wasn't aware we were arctic here...
  13. My mistake I thought barn meant house in Texas.

    My mistake I thought barn meant house in Texas.
  14. Replies
    7
    Views
    618

    Don't they call that a trap around here?

    Don't they call that a trap around here?
  15. You're on the early part of a house build and...

    You're on the early part of a house build and crying about $50 for a proper water line?

    Ditch the PVC crap.
  16. Replies
    21
    Views
    5,238

    A good applicator will "picture-frame" each stud...

    A good applicator will "picture-frame" each stud bay before filling it in.

    Essentially pointing the gun into that corner where the 1/2" gap would be to round the harsher corner before his first...
  17. Replies
    21
    Views
    5,238

    In my "basement", the foundation wall is only 44"...

    In my "basement", the foundation wall is only 44" above the slab and then there is a small stud wall on top of that, grade is about waist level.

    I framed a full height (slab to floor joist), stud...
  18. Replies
    21
    Views
    5,238

    I also said you might need to implement a system...

    I also said you might need to implement a system to take care of the water prior to spray foaming.

    Interior french drain, etc.
  19. Replies
    14
    Views
    2,515

    So the people who make the crap-vent say it's a...

    So the people who make the crap-vent say it's a good idea and everyone who makes basins and ejectors says it is not?
  20. Replies
    14
    Views
    2,515

    You cannot use an AAV on the ejector basin...

    You cannot use an AAV on the ejector basin anyways, the level in the pit rises and falls so air will be displaced not just drawn in... and AAV only allows are movement in one direction.
  21. John that small shower room w/ the toilet in it,...

    John that small shower room w/ the toilet in it, does water make it almost to the door or what?
  22. Replies
    21
    Views
    5,238

    I think if you have lots of hydrostatic pressure...

    I think if you have lots of hydrostatic pressure pushing moisture inside, you might need a system to take care of that...

    4" of foam wont allow much permeability at all, don't expect to dry to the...
  23. Replies
    21
    Views
    5,238

    Lower temperatures are more of a concern for your...

    Lower temperatures are more of a concern for your yield (liquid to foam), not adhesion.

    Adhesion is similar to most applications, you need a clean, dry, oil-free, well fastened substrate.

    Foam...
  24. Replies
    21
    Views
    5,238

    Of course it is a good choice. 2lb. per cubic...

    Of course it is a good choice.

    2lb. per cubic foot density

    2"+ depending on your budget (thick enough that the inside surface is above the dew point on the coldest day of the year)

    Open cell...
  25. Replies
    9
    Views
    1,054

    Are you sure you should be giving out advice...

    Are you sure you should be giving out advice here?

    There is obviously not enough pipe left to work with between those 2 fittings, buying more pipe doesn't solve this.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4