(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: schipperke; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.12 seconds.

  1. Replies
    6
    Views
    2,091

    Pex

    I like the White Pex Toilet Supply, cut to length and install. Looks Good..
  2. How its made

    I had a toilet where the rim was badly warped on one side, you can see how that can happen here, when removing from the mold., they are still pliable.

    ...
  3. Sure, that will work :rolleyes: Just wonder...

    Sure, that will work :rolleyes:

    Just wonder though, how sure are you the spot you set it on was dead level? Did you try placing over the flange without wax, and seeing how bad it was there? Heck...
  4. Acrylic Latex

    I used this looks real good. Spend the $5 for a caulk finishing tool, (lots of generic versions, less than half the price shown) works great.. perfect finish in ~5 minutes time. If you are only...
  5. Replies
    2
    Views
    1,670

    ah, another future serial killer.....

    ah, another future serial killer.....
  6. Replies
    8
    Views
    1,608

    Thanks for replies, will be setting wax rings on...

    Thanks for replies, will be setting wax rings on flanges this weekend, one new and a couple musical toilets. (swapping bathrooms)
  7. Replies
    17
    Views
    5,136

    Remove

    You probably do not need to get the torch close to the joint itself. I'd try cutting up a coffee can, flatten it out and configure to drop over the stub to shield the wall. I see more of a problem...
  8. Replies
    8
    Views
    1,608

    Wax Ring question

    I pulled a toilet, there is an ABS flange that resembles an LP (remember those?) left in a hot car. The flange is fairly flush with the finished floor , not on top. Should I go with a thicker than...
  9. Replies
    7
    Views
    1,612

    Great photo. Wonder what the client thought...

    Great photo. Wonder what the client thought while you were smashing a toilet in his bathroom... Postal Plumber?
  10. Spanner Flange

    Screw down a spanner flange on top. Put the toilet bowl bolts up through the spanner flange before fixing on top what you have. What you have looks flush to floor, so you have the space needed to...
  11. to adjust buttons I think there is a screw to...

    to adjust buttons I think there is a screw to raise or lower actuators. The flush valve is removed by just twisting to left and it pops out, you can check the disk settings on the valve.
  12. flush

    The two flush actuators do not look the same height, are both buttons functioning with only a little free play? The water level is raised by taking a clip off the inlet valve near bottom, you then...
  13. Shipping

    Just received a toilet tank, lid had the lugs broken off. The tank was shipped with the lid on the tank, not packed well in my opinion. I received a Toto earlier, very well packed. The tank lid...
  14. Thread: Incinolet

    by schipperke
    Replies
    0
    Views
    681

    Incinolet

    What I really want to know, is did the USS Eisenhower get captured?


    http://www.youtube.com/watch?v=CcwCVIiNxuw
  15. Wow , really hit a nerve it appears! Well, your...

    Wow , really hit a nerve it appears! Well, your edit makes one suffer through five minutes to get to the toilet levity. Your inference of my view of his rant is unfounded, I gave no opinion. Just...
  16. Sen. Rand Paul flushes his toilet ten times

    Not a good flush in 20 years

    http://www.youtube.com/watch?v=zvl961uDoEg&t=4m5s


    http://www.youtube.com/watch?v=zvl961uDoEg&t=4m5s

    Move the bar to four minutes and five seconds to get to...
  17. Replies
    32
    Views
    18,614

    All kinds

    I've seen posts from "men" where it takes a thread to explain how to install a standard flapper.

    I have an older American Standard Round bowl (down from two recently) where the water volume in...
  18. Replies
    5
    Views
    1,787

    Thanks much guys !

    Thanks much guys !
  19. Replies
    5
    Views
    1,787

    Toilet Bowl Seal

    I have seen some photos of toilet installs where the white silicone <?> sealer around the bowl at the floor does not extend to the rear of the base. Is there a reason for this? I can't recall...
  20. Replies
    32
    Views
    18,614

    Gary, its a long drive, but I have an UltraMax...

    Gary, its a long drive, but I have an UltraMax for you..:rolleyes:

    This Penguin scores 1000 on the MaP test
  21. Replies
    29
    Views
    8,445

    Sydney 305

    I should have one in shortly , after one month with another brand, tonight makes 4 plunges. Heck , worse than the old American Standard I pitched.. I will say the one I'm replacing flushes water...
  22. Replies
    6
    Views
    2,841

    Feed the Toto more Fiber

    Used a plain, thin wax ring. The waste gets cought at the first bend most likely, very quick. More fiber may be good for both me & the toto.. "Doctor my foot hurts" , "Eat more fiber" (Seems to...
  23. Replies
    29
    Views
    8,445

    Potato

    Well, looks impressive..


    http://www.youtube.com/watch?v=ESOwyMAf-mk
  24. Replies
    6
    Views
    2,841

    I'd trade the New Ultramax I just installed for...

    I'd trade the New Ultramax I just installed for my Old Crane Economiser with the Flushmate 503 any day. Pulled the plunger out again today.
  25. Instruction Manual

    See if you can trouble shoot it. I had a Crane Flushmate, many many years worked great.
    Flushmate 503
Results 1 to 25 of 43
Page 1 of 2 1 2