(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: scott_r; Keyword(s):

Search: Search took 0.12 seconds.

  1. Following up my own message...

    Well, I guess nobody wanted to take a guess or I violated the posting policy (my apologies for that if I did). I decided to take the least risk possible and went ahead and used 1" copper (sched. L),...
  2. Monoflow loop - moving a convector - couple of q's

    Heya gang - it has been a while since I've posted.

    I'm in the middle of a project to replace my boiler (a 1942 National Radiator Co., Johnstown, PA lump) with a nice new Munchkin...
  3. Replies
    11
    Views
    9,107

    Makes sense - this is 3/4" PE - I'll check the...

    Makes sense - this is 3/4" PE - I'll check the manufacturer's literature to find out what the bubble rising rate is.



    Sure, good old PV=nRT

    I hadn't really thought about this, but...
  4. Replies
    11
    Views
    9,107

    Well, that would be a neat way of ensuring the...

    Well, that would be a neat way of ensuring the highest point in the loop is in an easy place to bleed, but my house sits on a hill - so bringing the pipes in above the freeze line or below won't...
  5. Replies
    11
    Views
    9,107

    So, this is a tricky part - I am more or less...

    So, this is a tricky part - I am more or less stuck with putting the loop field uphill from the house or downhill - both the pump and the bleeder will be located in the house. However, it seems like...
  6. Replies
    11
    Views
    9,107

    Geothermal "horizontal" loop circulation

    Hello all,

    I've posted here before, but always with Q's about wells. This is a little different - an HVAC issue. I'm getting ready to replace my 35yo oil furnace before the cold weather arrives...
  7. Replies
    11
    Views
    1,578

    well, I didn't think there was the possibility of...

    well, I didn't think there was the possibility of polarity, but was grasping at straws, and yeah, I've got power on both legs of the circuit. I measured with a multi-meter to be sure, and I'm...
  8. Replies
    11
    Views
    1,578

    Polarity

    I forgot to add: does the polarity on a 2 wire system matter? I may have inadvertently reversed these when I stripped off the old ends and re-connected.
  9. Replies
    11
    Views
    1,578

    Reset a 2 wire w/o pulling?

    I have an unknown 2-wire pump in one of my 2 wells; I'd really, really like to avoid pulling it if possible. The well was running just fine until two days ago, when it simply didn't come on.
    ...
Results 1 to 9 of 9