Search:

You think the pump is bad? I was thinking it was something electrical.

Every time my pump (submersible) comes on, it is blowing fuses. What could be the cause of this? It is the only thing wired to the fuse box, and it has been ok for years until now.

Sulphur Specs? What is that? Is it fixable? We do not drink our water and only use it to shower and for laundry. It is a fact that the water in my area is not good. It tested drinkable but with...

We have had a breakthrough!! I was so disgusted because we have had only problems with this house. I turned on the water in the bathroom sink (the first faucet) and it seemed like it wanted to run...

See, when we run water we have no pressure, then the pump comes on and there isn't even a boost of water pressure. The fact that the tank doesn't keep 18 lbs in it ever, could be a bad tank. What...

If we are having problems with hot and cold pressure is it possibler the blockage is after the water tank but before the hot water heater? By airation do you mean the screens?

After we drained the tank yesterday the gauge on the pump and the tire gauge read 0. WE filled the tank with 18lbs of air by hand pump. When we turned the pump back on the tank filled and pump shut...

Please, somebody HELP! I have installed a new pump (meyers deep well jet pump) and a new water tank (bladder type). We have absolutely no water pressure. I mean there isn't even enough to come...

The pump is a Water Ace made by Meyers. Is a deep well, 1/2 HP, jet pump. The tank is a 20 gal. diaphram type tank.

We were reading 0# at both the gauge and the tank valve. When we turned the pump back on it pressured itlself back up to 37# and shut off.

We drained the tank, pumped 18# into it, turned on the pump,it shut off at 30#, we drained again, it now reads 0#. We turned the pump on with 0# in the tank, and it is now up to 35# and shutting off...

We just replaced our jet pump and our pressure tank. We set the tank pressure at 18psi, 2 less than pump cut in pressure of 20psi. After the pump runs the tank has 30 to 35 psi. This causes the...

Bob,
I have a Meyers pump now. There is also new developements in this drama. Last night my husband turned on the kitchen sink, and a pipe burst all over the place. My pump then went up to...

I have cleaned all of the faucet tips and showerheads. We replaced the old pump with the same kind. We are supplying the right voltage and this pump has the same gpm and hp. I thank you both for...

I forgot to say I keep turning the pump off when I am not using water, but it still reads 30 when it is on or off. Can all of this be because of a bad water tank. I have a bladder type it has about...

Dear Mr Slusser, We do have water, but absolutly no pressure with the cold. And it is orange, which could mean low well right? When I disected the old pump it was filthy inside and out with rust...

Help! We had no water for 3 days. The plumber said the pump was shot. We replaced the pump. We now have orange water, no pressure in any faucet and the pump stays at 30. It will not rise or...

I am having problems with my water. My pump keeps running and it keeps it's prime. My water tank (bladder type) will not fill and so I have no water. The gage on the pump reads 0. My well is not...