Search:

Isnt an AAV not allowed on a washing machine standpipe.
Couldnt he use the AAV to vent a utility sink which could catch the washing machine.

Why not plumb a laundry sink and dump the washing machine into it.

I dont know why they cant the system to work.
A TACO ZVC406 controller can work with a two, three or four wire zone valve.

In simple terms. The t-stat wires come in through the top of the ZVC 406...

I would think that the high and low limts would keep it within range

Just bought a house that has a EJM shower pan installed.

No leaks but the problem is that when you stand in it or move around it squeaks and makes all sort of noise.

My solution was to spray...

If you felt the price was too high, you had the option to keep shopping.

YOU choose to accept this electrical proposal! and the company doing the work as you stated has done everything that was...

I've seen where some DIYers have tightened the clamp so much that it shorted the wires.

I hope for both you this is NOT a multi family dwelling..

Someone correct me if I'm wrong, but I thought you were not allowed to make new knockouts on service entrance equipment. You had to use what was factory made.

My first house was built in 73. Had aluminum wiring but copper DWV. Go Figure!:)

You're WELCOME:D

Beacuase they dont want to tell you that it was your fault!!;)

The suspense is killing me:rolleyes:what were the coins for???????

What happens when that owner sells and the next owner doesnt want to play? There probably are other options, talk with your electrician.

check with the poco to see if they allow splices in a meter pan or check with the eleectrician thats going to be doing the work.

In your pic, the drywall is supposed be over the flange, not right up against.

Look at the bright side.....
Next year your lawn will be the greenest, then your neighbors will be jealous:eek:

I give;)
Should've read before I typed.
Lesson learned!;)

Depends,
He's still going to have to cut up the area for the j-boxes.

And no one mentioned what size conduit and what wire is in it.
Will he be running a new circuit in the exsisting conduit or...

For all the work of installing j-boxes wouldnt it be easier to run new like Speedy Petey suggested.

Since your picture only shows the posts,
Is there any way to pour a footing just outside of the patio and move your posts and header forward a couple of inches?
It'll save you from having to...

If thats daylight coming through the outside perimeter wall , I'd think about putting insulation there. (Heat loss to outside)
Also all of your loops are uniform, without an exterior zone loop which...

[QUOTE=Paso One;166293]I did exactly what you are proposing.

What water temp are you running through your zones?
And are you using a manifold?

Here in NY it would cost a fortune to running...

what color were the wires on the breaker?
(Did you take the white wire and land it on the neutral bar?)

Hey Roegs,

Is it possible to run a set of feeders in the way you mention or even through the gargae to a sub panel and then pull your circuits out from there.
You may also be able to get rid...