(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: FL Homeowner; Keyword(s):

Search: Search took 0.14 seconds.

  1. Been away from my project with travel for work. ...

    Been away from my project with travel for work.

    Thanks so much!! Yes! Nice catch on the San-Tee!!

    I will cut the final 3" pipe lengths one at a time and with consideration for fitting...
  2. Here we go... This is the dry fit. Any feedback...

    Here we go... This is the dry fit. Any feedback on the cleanout and any other comments are welcome... THANK YOU!!
    http://i752.photobucket.com/albums/xx165/kwboat/53/2012-08-20_15-28-39_629.jpg...
  3. I've got the 4' PVC into the the cast hub via...

    I've got the 4' PVC into the the cast hub via rubber donut from LOWES. It was a snug fit and I used soap to help slip the PVC into the donut. The donut was 3" wide and I got the PVC down 4" in...
  4. Alright.... I've cut the cast down to the lowest...

    Alright.... I've cut the cast down to the lowest hub. *This is actually a 90 into the ground. *I cleaned out the hub and its ready to accept a rubber donut into 4"PVC. *From there I have a drawing of...
  5. The framing is a non-bearing wall and will...

    The framing is a non-bearing wall and will support design. As for the rest of the house there is only a kitchen sink that is connected to septic via an outdoor vented pipe with an access plug. ...
  6. Thanks so much for the feedback..!! You are 100%...

    Thanks so much for the feedback..!! You are 100% correct - The main stack is consuming me...!! I'm okay with the new changes and think the trap vents will tie into a single within the attic and...
  7. OKay - With what I've learned, its best to...

    OKay - With what I've learned, its best to change the layout design to placing Shower/Lav/toilet on on the same wall and that wall is the best way to go. If I get too creative and press my luck and...
  8. Edit... Old info - moved to new design below.

    Edit... Old info - moved to new design below.
  9. Thanks for taking a moment to help sort this...

    Thanks for taking a moment to help sort this out...! I see your point.... The shower drain distance yeilds an approx 4' slope to reach the main stack.

    [Q] Since I have roughly 2' above,...
  10. Thank you! Stopped by for a visit with mom.... ...

    Thank you! Stopped by for a visit with mom.... I'm working on revised design to get closer to the existing vent for the lav, but the shower is a tough one... I've got the ceiling exposed and...
  11. Edit... Old info - moved to new design below.

    Edit... Old info - moved to new design below.
  12. Hi... thanks for your response!! I've yet to...

    Hi... thanks for your response!! I've yet to find an exact section that addresses the distance from the toilet to the main stack - 2010 FL Plumbing code doesn't clearly address that however does...
  13. 1954 Rehab [tile redi] full bath relo - Need feedback to get off the ground, please..

    Hello… Thankful to anyone that takes a moment to help… !! Learning tons and can't pretend to know it all... DIYr with more time than money...

    Looking for direct feedback on my rehab project....
Results 1 to 13 of 13