Search:

3239.55 in reply to 3239.20

Here's the reply I got back from the PPI PE...

Hi D

You are welcome – Pls see the discussions below and hope that is helpful for you-


.. in addition to...

I agree that it doesn't make instant sense that you can run 3/8" to anything but an icemaker.
But what really suprised me about the table is that they say that 3/8" is fine for a single head...

In case anybody else wants to read it the Plastic Pipe Institutes PEX design guide can be found here.

http://plasticpipe.org/publications/pex_handbook.html

Seems useful though I wish they'd...

I've Found The Answer!!!!
So it turns out the Uponor has a online forum. I asked in that forum the same question that I asked here...and here is what the Uponor employee said....

dneumansky, ...

Points well taken.
I bet that the plastic pipe guys did do the math and that's how they got the table...
With short runs, a bath lav and a modern low flow water closet why should they need more...

Hello All,

Here's the situation. I've got a situation that seems to be perfect for a pex home-run manifold.

I've got 2 bathrooms, a small kitchen, and a laundry room all with ~10' (as the crow...

Hi Lisa,

Yea we are used to it now. I especially like the soft close lid. I thought it was just an expensive gimic but now I like it.
Similar story to yours. A good friends FIL who is from...

Thanks for the reply. I guess we were scared to use it for a while because I was the one that installed it and we wanted to make really really really sure it was done right and would not leak.
I do...

so lets say I have the pinhole leaks in my copper pipe. I don't want to replace them what can I use to seal the leak? Is there some kind of epoxy or something that I could use that would be...