(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Terry; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.39 seconds.

  1. Replies
    7
    Views
    181

    The Falcon stainless is harder to seal at the...

    The Falcon stainless is harder to seal at the ends.
    I hate those service calls fifteen minutes after I leave a job.
    That never happens with copper.

    Copper costs more. That would be the only...
  2. Replies
    7
    Views
    181

    hj, that's the perfect answer. :)

    hj, that's the perfect answer. :)
  3. There appears to be some truth to that. We...

    There appears to be some truth to that.
    We don't buy our parts and material there. Been burned too many times.
    I have also found that "returns" go back on the shelf, sometimes after parts have...
  4. Replies
    7
    Views
    181

    I prefer the copper flex connectors over the...

    I prefer the copper flex connectors over the stainless.
    I don't use the braided supply lines for water heaters.
  5. Replies
    2
    Views
    94

    http://www.terrylove.com/images/replace_lead_bend....

    http://www.terrylove.com/images/replace_lead_bend.jpg
    I normally just pull the lead out of the cast iron tee, and use a 4x3 flush bush into a insert rubber pipe donut.

    Yes, a 4" hub closet bend...
  6. I was thinking about having lunch.I like the...

    I was thinking about having lunch.I like the natural drain cleaners. Bio-Clean is one that I use.you may need to remove the disposer and turned upside down to get all that junk out of it
  7. If your toilet has a connector made by Watts

    https://www.toiletconnector.com/

    A settlement has been reached with Watts Water Technologies, Inc. and Watts Regulator Co. (“Watts”) regarding Toilet Connectors with Coupling Nuts made with acetal...
  8. Replies
    4
    Views
    326

    They really like the brown color. I couldn't find...

    They really like the brown color. I couldn't find anything like it. It makes the lav, and goes well with their wall covering.
    They do have a TOTO Drake in the master in Bone.
  9. Replies
    8
    Views
    4,877

    The neck should lift off and up. That's where...

    The neck should lift off and up.
    That's where you can put a wrench on it.
  10. Replies
    4
    Views
    326

    http://terrylove.com/images/kohler/k-30668-parts.j...

    http://terrylove.com/images/kohler/k-30668-parts.jpg

    The K-30668 parts

    http://terrylove.com/images/kohler/k-30668-parts_5.jpg


    http://terrylove.com/images/kohler/k-30668-parts_4.jpg
  11. Replies
    16
    Views
    13,929

    http://terrylove.com/images/toto/neorest600_01.jpg...

    http://terrylove.com/images/toto/neorest600_01.jpg

    Neorest 600 in Beige
    Bellevue, WA

    http://terrylove.com/images/toto/neorest600_03.jpg


    http://terrylove.com/images/toto/neorest600_04.jpg
  12. http://terrylove.com/images/toto/vespin_green_2.jp...

    http://terrylove.com/images/toto/vespin_green_2.jpg

    Vespin II in Bellevue
  13. Replies
    7
    Views
    259

    I prefer a rough trapway. Smooth trapways...

    I prefer a rough trapway.
    Smooth trapways collect paper and wipes. It's hard for a wipe to stick to a rough surface. It's about funtion, not about how shiny it is.

    We install these bad boys all...
  14. 1.6 is not better than the II series from TOTO. ...

    1.6 is not better than the II series from TOTO.
    1.28 with Sanagloss rules!

    MaP ratings over 500 are kind of useless to read about. The most that will ever be flushed is 200 grams.

    The...
  15. Replies
    6
    Views
    130

    http://terrylove.com/images/homeowner/accord_wild_...

    http://terrylove.com/images/homeowner/accord_wild_07.jpg

    When the hole is cut in the end panel, there should be room for the valve. How big do you precut the access for the tub/shower valve?
  16. Replies
    13
    Views
    361

    It sounds like a recirc pump would help out. I...

    It sounds like a recirc pump would help out.
    I like to run a 1/2" line back to the water heater, with an aquastat that cuts off the pump when the return is warmed.
  17. From the Kohler instructions. ...

    From the Kohler instructions.

    http://terrylove.com/images/back_to_back_kohler.jpg

    A double wye fitting on the left is okay
    A double fixture fitting is marginal, it will still lose water in...
  18. The shower vent can tie in at 42" above the...

    The shower vent can tie in at 42" above the floor.
    I prefer to not have a toilet back to back with a fixture cross.
    My preference would be a wye below the toilet santee, with a vent coming off...
  19. Replies
    5
    Views
    133

    Moen comes with a round rough-in plate, that if...

    Moen comes with a round rough-in plate, that if the tile had been installed around that, you would have had proper access to the shutoffs.
    I hate it when tile setters don't give us the required...
  20. Replies
    10
    Views
    387

    That's pretty confusing. The toilet doesn't...

    That's pretty confusing.
    The toilet doesn't need a trap.
    I can't tell what the other stuff is doing.
  21. Most rounds bowls are bought because they sell...

    Most rounds bowls are bought because they sell for less. You won't see many upgrade features on round bowls.
    TOTO does make a Sanagloss round bowl in the Promenade.
  22. Replies
    9
    Views
    291

    You have two medium bends in the wrong location. ...

    You have two medium bends in the wrong location.

    From the wye, continue to the other side of the stud, and work backwards to the lav. You're trying to be too cute there, and you've run out of...
  23. Replies
    6
    Views
    224

    A 1.5" trap arm can go 42" before the vent A...

    A 1.5" trap arm can go 42" before the vent
    A 2.0" trao arn can go 60" before the vent.

    Do those windows go all the way to the floor?
    An inspector like to see a horizontal vent 6" above the...
  24. Replies
    0
    Views
    266

    WSSF at Blackcomb 2014

    WSSF at Blackcomb in Canada, 2014

    http://www.wssf.com/schedule

    James will be playing with his band Longstride at 2:30 PM at the Skiers Plaza on the mainstage Sunday the 13th.

    Maybe he will...
  25. Replies
    10
    Views
    2,599

    If someone has a manual for this, please send it...

    If someone has a manual for this, please send it and I can turn it into a pdf file.
    Terry
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4