(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: gregnoob; Keyword(s):

Search: Search took 0.12 seconds.

  1. Replies
    6
    Views
    422

    I didn't know about shark-bite fittings. That...

    I didn't know about shark-bite fittings. That looks like it would do the trick.

    Any tips on cutting the poly cleanly?
  2. Replies
    6
    Views
    422

    Sillcock with odd connection

    Good morning everyone,

    I've got a sillcock that is leaking like crazy. This started as a really slow drip and is now a steady stream. Trouble is that this house still has polybutylene piping...
  3. Replies
    4
    Views
    703

    Thanks... turns out that the threading looks bad...

    Thanks... turns out that the threading looks bad (gouged) on the male end of the connection and that's where I am getting the leak. I've got to cut the assembly off and I'll probably go with the 1...
  4. Replies
    4
    Views
    703

    Trouble with p-trap

    I am installing a new pedestal sink in my bathroom but ran into a problem with the p-trap assembly...

    I bought one of those kinds that has the 90 degree down turn that gets glued into the stub-out...
  5. Replies
    1
    Views
    690

    Badger 1 electrical requirements...

    Will a Badger 1 garbage disposal run off a dedicated 15A circuit?

    Specs:

    Type of Feed: Continuous
    On/Off Control: Wall Switch
    Motor: Single Phase
    HP: 1/3
    Volts: 120
    HZ: 60
  6. Replies
    15
    Views
    10,614

    Thanks everyone! I took your advice and went...

    Thanks everyone! I took your advice and went with the hard venting. It was actually a lot of fun running all the turns to get it up around the pass-through window!
  7. Replies
    49
    Views
    22,080

    Sums it up for me! I was debating an AAV rather...

    Sums it up for me! I was debating an AAV rather than the twisty vent I was going to have to run around a pass-through window. Reading this thread makes it all so clear. NO AAV!
  8. Replies
    15
    Views
    10,614

    Well thanks to everyone for the advice... Looks...

    Well thanks to everyone for the advice... Looks like I'm running the traditional vent!

    So... blue route or red route?

    Also, for ease of putting in the P trap and disposal, should I move the...
  9. Replies
    15
    Views
    10,614

    More Info...

    Just some pictures to show what I am dealing with. So far we're 2 to 1 against the AAV...



    1) This is how the drain pipe currently comes up. I am thinking about extending it to the red circle...
  10. Replies
    15
    Views
    10,614

    Final word on Air Admittance Valves

    Hey everyone!

    I just finished moving my kitchen sink about 10 feet. Moving the copper and drain was fairly simple (once you forget what hours in a tiny crawl space was like). The final step is...
Results 1 to 10 of 10