(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: lambtron; Keyword(s):

Search: Search took 0.13 seconds.

  1. Replies
    1
    Views
    2,030

    I suspect the hole is a pressure relief for the...

    I suspect the hole is a pressure relief for the valve's inner plunger shaft. If this is the case then the replacement screw should also have a hole in it to prevent the stressful pressure difference...
  2. Replies
    41
    Views
    25,330

    Problem solved

    Final Report:

    I installed a new hot stop valve yesterday and the leak is fixed.

    Although the cold stop valve wasn't leaking, I did notice some wear on the same o-ring that failed in the hot...
  3. Replies
    41
    Views
    25,330

    O-ring update

    I searched the Internet high and low but couldn't find a kit with o-rings that are even close to the size I need. In fact, I found only one supplier that lists the needed size (and it isn't...
  4. Replies
    41
    Views
    25,330

    I couldn't believe it either! I went to Home...

    I couldn't believe it either! I went to Home Depot, Napa Auto and a specialty plumbing supply store, and except for one o-ring I found, none of their in-stock o-rings were even close.


    That's...
  5. Replies
    41
    Views
    25,330

    Same problem, less costly solution

    Replacing the stop valves is an expensive way to fix this problem. I am currently working to solve this same problem (a slow leak in my Integrated Grohmix 34-436), but I hope to solve it in a less...
Results 1 to 5 of 5