(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Russ75; Keyword(s):

Search: Search took 0.13 seconds.

  1. I bought an EcoDrake and had the same problem...

    I bought an EcoDrake and had the same problem with streaks. I then got a DrakeII with sanigloss and whirling flush (can't think of the name) but it is no improvement at all. Both almost always...
  2. Replies
    9
    Views
    1,456

    Thanks for all the helpful feedback. I think...

    Thanks for all the helpful feedback. I think just to cover all the bases I will go with the Drake II (elongated, ADA and Sanigloss) for the main toilet.
  3. Replies
    9
    Views
    1,456

    By residue, I meant a smear of solids stuck to...

    By residue, I meant a smear of solids stuck to the lower part of the bowl, well below the waterline. The flush is complete and very strong, leaving nothing in the water or above the waterline. How...
  4. Replies
    9
    Views
    1,456

    Poor bowl rinse in new Toto EcoDrake

    I just got a Toto EcoDrake and it always leaves residue on the bowl, even after two flushes or holding the handle down for a long flush. Fortunately this is in a guest bath and will get little use. ...
  5. Replies
    28
    Views
    26,516

    Could someone tell me what the dosage directions...

    Could someone tell me what the dosage directions are for BioClean? Trying to get an idea how long 2 lb. would last.
  6. Replies
    5
    Views
    864

    Toilets and sinks erupted!

    I have a commercial building with 7 toilets and 7 sinks (no showers or other connections) on a single sewer line, which runs under the cement slab building to the street. The furthest sink is about...
  7. Replies
    3
    Views
    2,323

    Cutting tile on backsplash

    I am replacing my over the range microwave. I want to mount it directly against the wall, but I will need to remove about 8 inches of the top of the existing tile backsplash in order to get it back...
  8. Replies
    23
    Views
    5,884

    I called and got the same answer, so that's good...

    I called and got the same answer, so that's good news. I'm glad to know it's normal operation. They also said that if it senses it is jammed, it will increase the power to overcome the jam.
  9. Replies
    23
    Views
    5,884

    Thanks Mikey, I will also give them a call...

    Thanks Mikey, I will also give them a call tomorrow and let you know what response I get.
  10. Replies
    23
    Views
    5,884

    It's an Insinkerator Evolution Excel. I tried the...

    It's an Insinkerator Evolution Excel. I tried the wrench and it rotates smoothly and evenly. The problem started before I put any food through it, so it's not related to anything stuck in the...
  11. Replies
    23
    Views
    5,884

    OK, thanks..... I tried letting it run for a few...

    OK, thanks..... I tried letting it run for a few minutes, and no change. It still has a slight (fraction of a second) delay during which a faint humm is heard before it starts. Everything else is...
  12. Replies
    23
    Views
    5,884

    Hum and Delay in garbage disposal

    I just replaced my 3/4 hp. garbage disposal with a 1hp. When the switch is turned on there is a fraction of a second delay during which the disposal has a low hum before it starts to rotate. It is...
Results 1 to 12 of 12