(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: jpb116; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.10 seconds.

  1. Any internet sources for this would be appreciated

    Any internet sources for this would be appreciated
  2. I can't find a quick disconnect gas connector

    I'm sure someone here can help me ... I'm looking for a brass 3/4 inch quick disconnect valve for my propane line to my generator. The type that you slide the outer sleeve back : plug in the male...
  3. Replies
    6
    Views
    5,063

    So, if the tank is pumped and the environmental...

    So, if the tank is pumped and the environmental conditions are consistent... is the vent config in the drawing correct enough to be functional? Another question... Does the outside clean-out act as...
  4. Replies
    6
    Views
    5,063

    The tank is pumped yearly, and being only a...

    The tank is pumped yearly, and being only a basement bath tank means it doesn't get used too often.

    On the vent subject I should mention that the two vents are about 3 feet apart. This is a small...
  5. Replies
    6
    Views
    5,063

    Bubbling toilet and shower

    - I have a basement bathroom with 2 sinks a toilet and a shower.
    - The home has 2 septic systems so the basement setup has a dedicated septic system.
    - When my sinks run the toilet bubbles and...
  6. Replies
    7
    Views
    11,613

    Reverse osmosis - tank pressure?

    Hi all. what is the best pressure to charge a RO holding tank too?
  7. Replies
    4
    Views
    1,450

    nhmaster, I'm not sure I undertsand your...

    nhmaster, I'm not sure I undertsand your response... Are you suggesting that I plumb it with copper only? If I could I would, the area it's going can not support that type of install. I'll also...
  8. Replies
    4
    Views
    1,450

    what type of hose for a toe kick heater?

    Can I use a faucet hose, 30" steel braided over rubber, to tie in my toe kick heater? Or is there some special type of hose or this ?
  9. Replies
    4
    Views
    977

    Thanks HJ

    Yes, i do mean a Mono Flo tee. And thanks I thought I needed 2 but wasn't certain
  10. Replies
    4
    Views
    977

    Help with Toe Kick loop - parts question.

    I'm ready to install a toe kick heater. I believe I have all the parts I need I just have one last question. At the entry point of the loop I have a "dual directional tee" (sorry for not knowing...
  11. Replies
    1
    Views
    867

    my toe kick heater won't get hot? Help`

    No need to ask my question ... I just discovered I installed my mono flow T incorrectly ...
  12. Replies
    2
    Views
    832

    Pictures coming!

    I'll take some shot tomorrow and post them. !!
  13. Replies
    2
    Views
    832

    Project done and inspection complete!

    To everyone that helped out out with my bathroom buildout... Thanks!! We're approved (with a nice compliment from the inspector on the neatness of the work) and everything is working perfectly!!! ...
  14. Replies
    18
    Views
    19,316

    Thats what I thought.

    I'm going to change my shower base drain to an ABS version... No risk!
  15. Replies
    18
    Views
    19,316

    adhesive for pvc to abs?

    Is there one that exsists? My shower base is PVC equiped but my waste lines are ABS and I dont have room for a fernco...
  16. Replies
    5
    Views
    879

    position relative to the trap.

    So it's not proper to vent before the trap? That's good info, and the reason for my pic and question...
  17. Replies
    5
    Views
    879

    trap...

    The trap is below the drain. This setup is above the floor, the p-trap is below the floor between the joists.
  18. Replies
    5
    Views
    879

    Will this tub vent? Pic attached!

    Please bear in mind that the vent tube will be tied into the vent for the shower going through the roof.
  19. Not sure I have the right Thinset, thoughts?

    Hi all, I'm ready to put down my shower base which is a one piece molded presloped tile ready deal. The manufacturer recommends a latex modified thin set as a base. I also understand that I'd want...
  20. Replies
    8
    Views
    1,251

    Thanks Krow!

    And Terry, I'd never have made it through this project without your experts!
  21. Replies
    8
    Views
    1,251

    thats my problem...

    I'm not a contractor and the ones near me wont sell to me ... :(
    I need an online resource...
  22. Replies
    8
    Views
    1,251

    cant find no-hub couplings AARRGGHH

    Does anyone know where I can order plastic to copper no-hub couplers? I've been to 5 big box depots and some of the smaller guys and nothing! I need the ones that allow for the differant outside...
  23. Replies
    6
    Views
    1,365

    it's a dry vent ...

    All this being said, My intent is to demo the area... I'm going to vent to code in the rebuild. I was just curious how it would actually drain in this configuration ... mabe lucky?
  24. Replies
    6
    Views
    1,365

    just checked again ...

    The nearest vent is upstream and about 7 feet away...
  25. Replies
    6
    Views
    1,365

    Old tub with no vent, and it drains! Why?!

    So I have a tub/shower on the main floor of a ranch. It's 40 years old and during a remodel I've opened the ceiling below it (finished basement) The tub doesn't have a vent. Just the standard...
Results 1 to 25 of 37
Page 1 of 2 1 2