(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: tedn332; Keyword(s):

Search: Search took 0.40 seconds.

  1. Replies
    2
    Views
    1,845

    LP to NG change-over

    I have a Reliance 501 model 530 gas water heater in a mobile home that we moved from the country into town. It is set for LP and we need to switch it to Nat gas. Detailed directions for changing it...
  2. Replies
    12
    Views
    2,228

    Thanks for all the input. Think I'm on the right...

    Thanks for all the input. Think I'm on the right track now; bring copper thru floor, bracket it to back wall of cabinet.
  3. Replies
    12
    Views
    2,228

    working with pex

    When I run pex through floor to kitchen sink, vanity or toilet, what is a neat way to trim out when it enters the cabinet. When coming through a wall I use a 5/8x3/8 comp fitting cut close to the...
  4. Replies
    2
    Views
    1,437

    pex crimp tools

    I have the Zurn pex crimp tools (1/2 and 3/4) . Confused with the compatability charts - will these tools work with the Vanguard crimp rings and fittings? Thankyou, Ted
  5. Replies
    1
    Views
    859

    underground pex?

    Can I tie in to the well pit with pex tubing to supply the house underground?
  6. Replies
    1
    Views
    1,226

    Vanguard HDPE tubing

    Have a large roll of this tubing with markings "vanguard procore hdpe (cts - od) 200 psi @ 73 degrees ASTMD-2737" etc etc. Best I can tell from search is it is for potable water, cold only. Can't...
  7. Replies
    1
    Views
    731

    cutting cast

    Plain metal-cutting blade should work fine. Once in a great while I've run into some that is hard as can be so I put a metal cut-off disc in 4" angle gringer and buzz around it.:)
  8. Replies
    20
    Views
    2,981

    Could you add 2X2's to the studs to give room for...

    Could you add 2X2's to the studs to give room for 2" pipe?
  9. Thread: Priming Pump

    by tedn332
    Replies
    3
    Views
    1,070

    It is a deep well jet. Hadn't thought about the...

    It is a deep well jet. Hadn't thought about the freeezing; that's a good possibility. Will lift motor tomorrow and take a look. Thanks
  10. Thread: Priming Pump

    by tedn332
    Replies
    3
    Views
    1,070

    Priming Pump

    Have a well approx 50' deep with a 1/2 hp jet pump. This pump was new 1 1/2 yrs ago. About six months ago we discontinued using this well and just yesterday tried to get it going again. I poured...
  11. Replies
    2
    Views
    1,195

    tub replace

    All kinds of variables here. Just installed Vikerell (great unit) for a customer where quite a bit of plumbing had to be updated. Re-plumbed, sheetrocked over enclosure; homeowner took care of the...
Results 1 to 11 of 11