(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: JohnO; Keyword(s):

Search: Search took 0.13 seconds.

  1. Replies
    3
    Views
    1,230

    Replacing Outside Faucet - close to house

    The faucet is close to the house which has vinyl siding and there is a decorative piece behind the faucet. There is only about 1 inch from the soldered joint on the faucet to the decorative vinyl...
  2. Replies
    1
    Views
    1,538

    Water Softener - Tankless

    Hi, do you need a water softener if you have hard water and want to install a tankless system? Another problem to deal with in deciding what system to go with. Thank you.
  3. Replies
    2
    Views
    6,416

    Boiler (cost and installation)

    I need to replace my boiler and I am not familiar with what is out there. The existing one is 37 years old.

    Can somebody recommend a good middle of the road product to heat a 2000 sq foot house?
    ...
  4. Replies
    8
    Views
    13,972

    Dishwasher Installation / Cabinets

    I will be installing a new dishwasher once I complete installing my cabinets. My question is for a dishwasher that will sit between two cabinets, do I leave the space exactly 24 inches or should I...
  5. Thread: Tile - New Floor

    by JohnO
    Replies
    1
    Views
    841

    Tile - New Floor

    I am going to be tiling a bathroom. The question I have is do you put the tile down and put the flange OVER the tile or do you put the flange in first and tile AROUND the flange? Thank you.
  6. Replies
    2
    Views
    751

    Faucet Installation

    I finished one bathroom and now onto another. Both faucets are single handle Moens

    For bathroom number 1, I sweated the fittings without removing the cartridge. It works fine.

    For bathroom...
  7. Replies
    1
    Views
    872

    Raising Floor - Toilet Flange

    I have 3 inch (copper pipe) drain for my toilet and the copper flange was secured to the plywood floor and there was tile put around the flange.

    I am redoing my bathroom and want to add 1/4...
  8. Replies
    1
    Views
    695

    Hot Water in Sink

    When I turn on the hot water in the bathroom sink, it comes on normal, then about a second later I hear noise in the pipe, and the pressure immediately drops. The noise is like a "boom".

    I had...
  9. Replies
    1
    Views
    1,789

    Furnace Not Working

    I hear what I believe to be the circulator continuously running and the pilot light is on. However, I cannot get the furnace to run and I am not getting any heat. I know that the contacts are closed...
  10. Replies
    1
    Views
    960

    Shower Door Installation

    I am putting in a new shower. It will be a kit with 3 walls and the pan. For the shower door, do I need to put two studs (one for each side)behind where it will go? If not, then will the fiberglass...
  11. Replies
    2
    Views
    1,400

    Shower Door Installation

    I am putting in a new shower. It will be a kit with 3 walls and the pan. For the shower door, do I need to put two studs (one for each side)behind where it will go? If not, then will the fiberglass...
  12. Replies
    5
    Views
    1,308

    Basic Soldering - Shower Installation

    This past weekend I converted my two handle shower system to a one handle system. This is my first attempt at installing a new bathroom - shower only with no tub. It took 6 attempts before I got it...
  13. Replies
    5
    Views
    2,003

    Show pan installation

    I am about to install a shower pan as a part of the Kohler-Sterling package which includes the three walls. Should I put down roofing felt or some other material underneath? I dont want to put...
  14. Replies
    2
    Views
    6,771

    Cutting 2 inch and 3 inch copper pipe

    Is there a good tool out there to do the job? I would rather not use a hacksaw or a dremmel. The only tubing cutters I can find only go up to 1inch and I think an 1/8.

    The two inch copper pipe if...
  15. Replies
    7
    Views
    2,383

    Thanks for the responses. It would not be...

    Thanks for the responses. It would not be feasible for me at this point to start with the copper flange and make a transition to PVC since another bathroom drains into the same line..

    All I want...
  16. Replies
    7
    Views
    2,383

    Copper Pipe - 10 foot lengths??

    I am remodeling my bathroom. For the toilet, I removed the flange as well as the 3 inch long and 3 inch wide copper pipe that went into the flange. I thought it would be no big deal to pick up...
Results 1 to 16 of 16