(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: bimmer; Keyword(s):

Search: Search took 0.12 seconds.

  1. Replies
    1
    Views
    953

    Master bath remodel

    I am rdemodeling my master bath. The orig. bath had a bedit next to where the new shower wall will be. I am getting rid of the bedit and want to use its water supply (h & c) as the source for my...
  2. Replies
    2
    Views
    3,375

    Installing thermostatic mixing valve

    I am installing a thermostatic mixing valve in my shower. Instruction manual says to install water hammer arrestors. The shower that I am replacing had no such arrestors and there was no noise from...
  3. Replies
    9
    Views
    1,186

    problem with abs fitting

    Hi Patrick88

    I agree, not much of a choice in this case.
    Thanks for your advice.
  4. Replies
    9
    Views
    1,186

    problem with abs fitting

    Hi Partick88

    Finally reduced the size of these pics. Hope you can make out what I am talking about.
    One pic shows the 4" abs with "stiffener" on underside. At the near end is the rubber coupling...
  5. Thread: steam shower

    by bimmer
    Replies
    4
    Views
    1,323

    steam shower

    Hi Frenchie

    Installation manual calls for cold or hot water line, however hot water is preferable.
  6. Replies
    9
    Views
    1,186

    problem with abs fitting

    Patrick88

    I tried to send jpg pics of drain. One w/rubber coupling attached, one w/cut-off collar of 90 and one showing drain, slab and new hole/trench where new p-trap and drain pipes will go....
  7. Replies
    9
    Views
    1,186

    problem with abs fitting

    I am relocating my bath tub. I need to move the drain (which is under concrete slab) approx. 2' at 90 deg. angle. The drain is 2" abs. My problem is that there isn't enough clean abs for new...
  8. Thread: steam shower

    by bimmer
    Replies
    4
    Views
    1,323

    steam shower

    I am remodeling my master bath and have a few questions.
    1)The new shower wall is within 1 foot of a 1/2" copper water supply (H & C thru concrete slab) that was used for the bidet but no longer...
Results 1 to 8 of 8