(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Iknownothing; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.14 seconds.

  1. Bump ;) , No one?

    Bump ;) , No one?
  2. Thumping/Banging noise from Hot Water tank.

    Hello, Just replaced the elements in my HW tank and two days later there is this sort of thumping/banging noise coming from the top of the tank. I'm not sure how to describe it really. Hot water...
  3. Replies
    7
    Views
    1,129

    and I guess its that hot now because the old...

    and I guess its that hot now because the old elements where so covered in calcium the previous owners probably had to turn it up to get it hot enough
  4. Replies
    7
    Views
    1,129

    K so could I change the temp without turning off...

    K so could I change the temp without turning off the Power?
  5. Replies
    7
    Views
    1,129

    Heater Tank Temp too hot!!!

    I just replaced both my elements in my HW tank and the old ones were caked with calcium. It took maybe 30-40 mins for the 50 gallons to heat up. The thermostat is set to 150 degrees and was wondering...
  6. Replies
    53
    Views
    3,733

    12pm-The water is too hot!!! That's great round...

    12pm-The water is too hot!!! That's great round here considering we haven't had water in 3 days. So again, Thank you all for your expert advice and especially Wayne. You are a true person, great...
  7. Replies
    53
    Views
    3,733

    Well Day 3... I have to give it to...

    Well Day 3...

    I have to give it to "McconnellPlumbing", I was on the phone from Toronto to Oklahama at 1030pm last night with him helping me figure out what the problem is. Turns out because I...
  8. Replies
    53
    Views
    3,733

    Well, it's been on for 12 hours now, and I...

    Well, it's been on for 12 hours now, and I drained a bit from the tank and a bunch from the taps to see the clearity change. So more cold water has been put in while still trying to heat the freezing...
  9. Replies
    53
    Views
    3,733

    Thanks, is there another kind of filter i could...

    Thanks, is there another kind of filter i could get? And should I wait a few days to see if the hot water ( now just still warm) clears up, because it is cloudy. Or should I drain bladder again and...
  10. Replies
    53
    Views
    3,733

    OKAY, I figured it out. Here goes... ...

    OKAY, I figured it out. Here goes...

    It was a sediment problem. Yesterday I wanted to clean out my Water Softener and start fresh. So I emptied the tanks while shutting off the power to...
  11. Replies
    53
    Views
    3,733

    I guess it's just going to cost this ol sucker...

    I guess it's just going to cost this ol sucker 300 to get a plumber out here whos' going to laughed at what a simple job this was. I can say I tried and gave it my all. Thanks anyways guyg.
  12. Replies
    53
    Views
    3,733

    The water fills up the Bladder tank then when it...

    The water fills up the Bladder tank then when it gets to the UV light it seems to slow right down or stop really. Because now after 2 minutes, with the valve before the HW tank open, nothing is going...
  13. Replies
    53
    Views
    3,733

    K so verdict is, Empty everything, faucets open....

    K so verdict is, Empty everything, faucets open. Bladder air pressure reads 28psi. Gauge reads 0psi. Now I want to turn on the pump but should I keep the faucets open? there is also three shut off...
  14. Replies
    53
    Views
    3,733

    Well-rite, I keep the valve closed after the tank...

    Well-rite, I keep the valve closed after the tank til it fills, then I slowly open it up at it rushes on to the softener. I don't think it's damaged. Besides it was working today, I just did the...
  15. Replies
    53
    Views
    3,733

    I think my problem is after the Jet pump and...

    I think my problem is after the Jet pump and Bladder tank, but what could block the water from coming up even just the cold water. It rushes from the bladder tank through softener and then it's just...
  16. Replies
    53
    Views
    3,733

    No the HW tank filled up the first time to what...

    No the HW tank filled up the first time to what seemed to be normal, than when I had no pressure, I drained the tank and started over now 3 times. now I am draining both tanks and faucets open. To...
  17. Replies
    53
    Views
    3,733

    Pressure gauge is right beside bladderr tank at...

    Pressure gauge is right beside bladderr tank at the bottom, when i drain it, I think it goes down to 40 but I can do it quikly now if you got the time. Thanks guys a lot. And should i be keeping a...
  18. Replies
    53
    Views
    3,733

    then you will not be storing any water in the...

    then you will not be storing any water in the bladder storage tank under pressure. The pump will turn on, and since the water can't compress, almost immediately hit the shut off pressure, and stop....
  19. Replies
    53
    Views
    3,733

    No it's weird, there is no pressure out of the...

    No it's weird, there is no pressure out of the faucets. Can i drain everything again and start over. And if so should i follow certain steps?
  20. Replies
    53
    Views
    3,733

    No I hear what you are saying but the pressure at...

    No I hear what you are saying but the pressure at the top when empty reads 28psi. I think I'm on 30/50, not sure cause when the tank fills, the pressure at the bottom gauge reads 65. I know 100%...
  21. Replies
    53
    Views
    3,733

    It filled up nicely the first time, but now twice...

    It filled up nicely the first time, but now twice and three times of emptying abd filling, it seems to be taking longer to fill up. I see what you are saying with the obstruction, but I bypassed the...
  22. Replies
    53
    Views
    3,733

    the well pump works fine, cuts in at 45 psi or so...

    the well pump works fine, cuts in at 45 psi or so and shuts off when the bladder gets to be 65 psi. No problem there.
  23. Replies
    53
    Views
    3,733

    There is a pressure gauge, but I'm sure it works...

    There is a pressure gauge, but I'm sure it works fine, when I empty the tank it goes down to 40 psi.
  24. Replies
    53
    Views
    3,733

    Any clues?

    Any clues?
  25. Replies
    53
    Views
    3,733

    I think it might be air in the lines because the...

    I think it might be air in the lines because the kitchen faucet for a couple seconds made this loud rough noise when I turned it on. But stopped after 3-4 seconds.
Results 1 to 25 of 40
Page 1 of 2 1 2