(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: jdgoodman; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.16 seconds.

  1. Replies
    3
    Views
    1,314

    Vent pipe

    Only use vet B.
  2. Replies
    6
    Views
    2,427

    Silicone!!!

    Silicone!!!
  3. Seems a little high to me as well and I work in...

    Seems a little high to me as well and I work in Seattle, But I canít see it. Most of it depends on the difficulty of the connection inside the home.
  4. Replies
    4
    Views
    829

    Im my area if you have a PEX system you do not...

    Im my area if you have a PEX system you do not need hammer arrestors.
  5. Replies
    8
    Views
    1,270

    No you will need to vent the new toilet in the...

    No you will need to vent the new toilet in the basement seperatly.
  6. Replies
    8
    Views
    1,796

    I installed that moen faucet and the customer was...

    I installed that moen faucet and the customer was very disapointed. It will not allow 100% hot water. I dont know the exact mix ratio but if you turn it all the way up you get about 90* water temp. I...
  7. Replies
    25
    Views
    14,417

    You would not be able to use a double wye on a...

    You would not be able to use a double wye on a back to back setup because the weir of your trap would be higher than you vent take off. UPC accepts san crosses if the barrel is 2 pipe sizes larger...
  8. Replies
    10
    Views
    1,394

    You would have 2 T&P valves if the drain from the...

    You would have 2 T&P valves if the drain from the one on the water heater could not be piped to the exterior of the house or if there is no floor drain near the discharge point in the home. 1st one...
  9. Replies
    41
    Views
    11,705

    We have a winner

    We have a winner
  10. Replies
    8
    Views
    1,699

    If its 12 years old i would replace it.

    If its 12 years old i would replace it.
  11. Replies
    4
    Views
    2,586

    Yes wirsbo does have good fittings in my opinion...

    Yes wirsbo does have good fittings in my opinion and they come in plastic or brass. They also produce manifolds, I would stick to the same brand the whole way through.
  12. Replies
    5
    Views
    2,723

    You will need a chain cutter for the cast iron...

    You will need a chain cutter for the cast iron pipe. If you arnt hurting for space near that stack and you plan on doing this yourself you might consider this next option. Get a syteline torch and...
  13. I'm sorry to say that you have gotten yourself...

    I'm sorry to say that you have gotten yourself into a world of hurt by letting your contractor do his own plumbing. As far as your issues go it is extremely difficult to diagnose all of these...
  14. Replies
    3
    Views
    2,213

    If im understanding you explination correctly yes...

    If im understanding you explination correctly yes you can do that. Or you can drain your dishwasher into the disposal and cap off the extra drain.
  15. 99* Of Takagi calls i go on i find a reason they...

    99* Of Takagi calls i go on i find a reason they are not functioning. Its always the same story, Bad venting, gas issues, poor placement or just no maintenance. I thought i was a tankless pro until i...
  16. Replies
    3
    Views
    3,943

    This is normal when firing up a heater.

    This is normal when firing up a heater.
  17. Replies
    4
    Views
    1,122

    Make sure the cold water valve above your water...

    Make sure the cold water valve above your water heater is turned on. Do you have galvanized steel water piping in your home? If so the hot water piping tends to clog up with debris more than the cold...
  18. Replies
    6
    Views
    690

    sounds like dip tube to me.

    sounds like dip tube to me.
  19. Replies
    6
    Views
    1,236

    You can not drain a fixture on one floor into the...

    You can not drain a fixture on one floor into the vent of another fixture on the floor below. The toilet on the bottom level is most likley re-vented but the one on the main level is not. I have seen...
  20. Replies
    13
    Views
    3,640

    Bradford White is my first choise.

    Bradford White is my first choise.
  21. Replies
    7
    Views
    686

    80 lbs is the max water pressure allowed in a...

    80 lbs is the max water pressure allowed in a domestic water system. 81 lbs you would be required to install a prv. Your water pressure will fluctuate during hi and low usage times in your...
  22. Replies
    5
    Views
    982

    Practice soldering a bit more, CPVC is an option...

    Practice soldering a bit more, CPVC is an option but i would avoid it.
  23. Replies
    3
    Views
    1,515

    pex manifold

    The distance 18" you are seeing is developed length of piping not the actual distance from the water heater. You need 18" of metalic piping connected to your water heater before you transition to...
  24. Replies
    10
    Views
    2,224

    I think you know what i meant. Thanks for the...

    I think you know what i meant. Thanks for the french lesson.
  25. hang ups

    All approved fittings and pipe in any material are designed to let liquids and solids pass freely. As long as you have the correct grade on your piping and use drainage pattern fittings where...
Results 1 to 25 of 35
Page 1 of 2 1 2