(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: MAoilTech; Keyword(s):

Search: Search took 0.15 seconds.

  1. try running ur ac again pull the tstat from its...

    try running ur ac again pull the tstat from its base does it shut off the unit? if so good if not you got a bad issues.
  2. Replies
    7
    Views
    3,208

    DonL nail it just wanna add a restriction in the...

    DonL nail it just wanna add a restriction in the lines such as plug filter dryer, Txv, Orfice most likely low on ref if so then you have a leak or the unit was not properly charge.
  3. u need to check where the drain is connected to...

    u need to check where the drain is connected to might have a hair line crack or the seal is no good I would replace the whole drain where it connects from the unit hope it helps.
  4. Replies
    7
    Views
    4,147

    where about in NH are u from mike take some pics....

    where about in NH are u from mike take some pics. here a back door to get u in http://www.taco-hvac.com/en/library.html#
  5. Replies
    7
    Views
    4,147

    check the wiring...

    check the wiring http://www.taco-hvac.com/uploads/FileLibrary/IV311.pdf
  6. Replies
    5
    Views
    1,799

    What is the boiler pressure when it is running?

    What is the boiler pressure when it is running?
  7. Replies
    3
    Views
    3,588

    Sound like the pipe thread die was no good or...

    Sound like the pipe thread die was no good or they do not know how to thread pipe did they use pre-treaded pipe at all if so are they leaking too?
  8. Replies
    6
    Views
    4,265

    Before you go ahead and spend your hard earn cash...

    Before you go ahead and spend your hard earn cash my advice will be replace your boiler it's close to 20 yrs old i'll hate to see if you spend the $$$ then a years or 2 it dies I know how it...
  9. Replies
    6
    Views
    4,198

    You dont have to re-pipe go with Plumber #1 as...

    You dont have to re-pipe go with Plumber #1 as for plumber #2 send him on his way.
  10. Replies
    6
    Views
    4,198

    We Use Blk Mal fittings & pipe, Oxygen in any...

    We Use Blk Mal fittings & pipe, Oxygen in any hydronic heating system is a killer proper installation of the unit can avoid air issues, Copper has a higher heat Conductor rating over blk mal thus we...
  11. Replies
    35
    Views
    15,551

    Some have Pride in what they are doing some do...

    Some have Pride in what they are doing some do not if your handyman has his oil license all good the issue with non-license oil teck's come's down to insurance this happen to a lady in the town I...
  12. Replies
    3
    Views
    1,965

    Agree's with pete, aquiety, T-stat,Limit Control,...

    Agree's with pete, aquiety, T-stat,Limit Control, or your Primary Control specially if you have R8184G type control (grey box with a red button) Contacts get worn out make the control click on and...
  13. Replies
    35
    Views
    15,551

    350? for aqua-stat? I think you mis-read it the...

    350? for aqua-stat? I think you mis-read it the tech that came to your house charge you 350 for a cad cell? not for the aqua-stat click link
    ...
  14. Replies
    8
    Views
    8,687

    Agree's with peter

    Agree's with peter
  15. Replies
    35
    Views
    15,551

    I'm a Master Oil Tech I'm Reading whats going on...

    I'm a Master Oil Tech I'm Reading whats going on just adding my 2 cents

    your aqua stat setting to high (This time got up to about 205 w/15 psi.) @ 30 psi and over your relief valve will let go...
  16. Replies
    2
    Views
    2,278

    it should be @ the chimney or @ boiler and not on...

    it should be @ the chimney or @ boiler and not on the run so have a thimble in the chimney then ur reducer / increaser then ur flue pipe but each state town's has they own rules.
  17. Replies
    8
    Views
    2,491

    i would say get a portable water expansion tank...

    i would say get a portable water expansion tank install reason if T&P valve letting go after been replace only thing i can think of when your water heats up it builds up pressure to much of will let...
  18. Replies
    20
    Views
    13,226

    this will help alot if your oil is gel up alot...

    this will help alot if your oil is gel up alot during the cold i use it myself it works very well.

    http://www.fppf.com/homeheating.asp
  19. Replies
    7
    Views
    3,064

    What brand model is your boiler? Also send me...

    What brand model is your boiler?
    Also send me what info you have.
  20. Replies
    5
    Views
    1,924

    Replace all 3 play it safe water feed relief...

    Replace all 3 play it safe water feed relief valve and expansion tank and after that bleed the system out :)
  21. Replies
    13
    Views
    12,720

    Poll: Buderus hands down :)

    Buderus hands down :)
  22. Poll: is that tub realy safe just dont be under it...

    is that tub realy safe just dont be under it while its in use :eek:
  23. Replies
    4
    Views
    1,582

    try bleeding out your system to see if it stops

    try bleeding out your system to see if it stops
  24. Replies
    1
    Views
    1,541

    Follow your state and local Codes if it tells you...

    Follow your state and local Codes if it tells you to use type L use it there is a reason.
    Type L vents are suitable for use with gas or oil. They can be used instead of a B vent, but a B vent can't...
  25. Replies
    11
    Views
    4,816

    Hey Wes Normal Range for you aqua-stat should be...

    Hey Wes
    Normal Range for you aqua-stat should be HI 180 Lo 160 with a diff of 20.
    other words your boiler will run till 180 then shut off when it hits 160 it will turn on again.it will only turn on...
Results 1 to 25 of 25