(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: jeffreyhel; Keyword(s):

Page 1 of 3 1 2 3

Search: Search took 0.12 seconds.

  1. Replies
    2
    Views
    1,053

    leaving the hot and cold faucet valves in the...

    leaving the hot and cold faucet valves in the open position and using your infrared EZ faucet has caused a direct CROSS CONNECTION where cold water can pass directly to the hot side causing problems...
  2. Replies
    1
    Views
    1,512

    I had one that a homeowner had like that and the...

    I had one that a homeowner had like that and the only thing I could think of was using a very long extention hose on a can of minimally expanding foam and drilling several holes behind the walls to...
  3. Replies
    4
    Views
    6,415

    I have no experience with them but noticed that...

    I have no experience with them but noticed that only two of them had the UPC code marked by it. The London and Roma
  4. Replies
    5
    Views
    2,873

    With a mono-flow system you must take out the...

    With a mono-flow system you must take out the unused monoflow tees to keep proper water flow through the system If you have a 1 in x 1/2 x 1 in mono flow tee and then you cap the 1/2 you basically...
  5. Replies
    5
    Views
    1,529

    Cass-- I never touched the water heater before. ...

    Cass-- I never touched the water heater before. I live in NJ so it had been years for me to get down to WVa.

    tooloholic---Yes they were told to have an electrician to look at the circuit panel as...
  6. Replies
    3
    Views
    1,367

    Yes we are here. You have two problems.. 1. If...

    Yes we are here. You have two problems..
    1. If you have done air purging(bleeding) of a system before then a question or two wouldn't hurt. If you have never done it there are too many tricks of...
  7. Replies
    5
    Views
    1,529

    Electricified Shower

    I was thinking about all the weird stuff that I have seen over the years and here is one that I found at my grandparents house in WVa .

    I was turning the tub/shower valve on and felt a little...
  8. Replies
    3
    Views
    1,061

    Like Terry said, PEX is good stuff and needs more...

    Like Terry said, PEX is good stuff and needs more support. In very tight spaces where fittings are inbetween beams you really need to figure out how to put everything together since the Aquapex...
  9. Replies
    2
    Views
    1,298

    It sounds like a bad bypass. Anyway replacing the...

    It sounds like a bad bypass. Anyway replacing the whole thing will solve the problem but MAKE SURE you get either another one that has the bypass or install an expansion tank.
  10. Replies
    11
    Views
    2,881

    HJ said "Don't worry about holding back since you...

    HJ said "Don't worry about holding back since you should not have to do it, and if you did, then the valve would probably break and need replacement anyway."

    So If I read this right ---if you hold...
  11. Replies
    11
    Views
    2,881

    I usually a small pair of channel locks to turn...

    I usually a small pair of channel locks to turn them initally. Make sure they are not plastic stems. If they are metal stems then you can apply wd-40 spray and wait a few minutes. Then you can...
  12. Replies
    2
    Views
    1,211

    equal quality but better design is Delta Monitor...

    equal quality but better design is Delta Monitor or if you can afford it a grohe valve.
  13. Thread: flies?

    by jeffreyhel
    Replies
    4
    Views
    1,375

    Sewer flies can be found in most sewers and I...

    Sewer flies can be found in most sewers and I would not clean your drain line just because you found a fly. Just cover up the hole well until you get your toilet installed. Just my opinion.
  14. Master Plumber Mark You said they will pay you...

    Master Plumber Mark You said they will pay you $300 for a heater. What about water heaters that are not up to code, chimneys that faulty, copper gas lines that need to be changed to black pipe or...
  15. Replies
    3
    Views
    1,526

    Setting the shower pan directly on the concrete...

    Setting the shower pan directly on the concrete floor is fine. Follow the manufacturers directions for what to set it on or in. NO, there is no room under the pan to offset it unless the verticle...
  16. jadnashua, yes the material under a perfect...

    jadnashua, yes the material under a perfect install will outlast a leadpan. The problem is from the words on the page to the product actually getting installed are two totally different things. I...
  17. Replies
    12
    Views
    2,396

    [QUOTE=jeffreyhel]http://www.solardeathray.com/ima...

    [QUOTE=jeffreyhel]http://www.solardeathray.com/images/army1.jpg

    Your Army is going DOWN !!--- Terry, down the toilet that is. Good update! Is that how you reduce stress?
  18. thanks for the pictures Terry!

    thanks for the pictures Terry!
  19. Replies
    1
    Views
    953

    I wouldn't worry about it. Moen and Delta and...

    I wouldn't worry about it. Moen and Delta and others make repair plates if the valve needs to be replaced. Just make sure if you are in a cold climate area to insulate the walls and pipes well.
  20. Replies
    11
    Views
    2,525

    The best garbage disposal is the Garbage Can. ...

    The best garbage disposal is the Garbage Can. With that said, I install ISE for my customers that have to have them.
  21. Replies
    5
    Views
    2,176

    I have a few easy questions about installing a...

    I have a few easy questions about installing a dishwasher.

    1) Home Depot = not exactly sure about home depot but what you have described sounds like the normal tubing that comes with a new...
  22. Thread: Tub install

    by jeffreyhel
    Replies
    10
    Views
    2,286

    for a professional plasterboard tiled wall...

    for a professional

    plasterboard tiled wall removed around tub 1-2 hrs

    shut water off and remove existing cast iron tub and valve. 1 hr

    break for bs 1 hr--that was alot of work

    clean area...
  23. The last one I had to do I had to drop the...

    The last one I had to do I had to drop the ceiling even more to be have proper ceiling insulation. Unless you are going to do a fiberglass or acrylic base, have an experienced plumber install a lead...
  24. Replies
    12
    Views
    2,396

    http://www.solardeathray.com/images/army1.jpg ...

    http://www.solardeathray.com/images/army1.jpg

    Q-tips are famous for clogging toilets. It only takes 1. Do you have anything on top of the tank or shelves above missing caps, lids etc. Did you...
  25. http://www.fernco.com/images/cv_inst.gif ...

    http://www.fernco.com/images/cv_inst.gif

    Depending on which type of check valve it is , it may be normal. I usually install a Fernco Check valve which is alot more quiet....
Results 1 to 25 of 60
Page 1 of 3 1 2 3