(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: holidayisle; Keyword(s):

Search: Search took 0.26 seconds.

  1. Replies
    0
    Views
    1,935

    Fault Light

    Hi All
    I need some help with a fault light on Rain Bird ESP-12LX Plus. The light comes on when I have zone 1 on and nothing happens. So I assumed
    that the solenoid was bad and I replaced it. Still...
  2. Replies
    25
    Views
    2,747

    Update

    Hi, the switch points are open when the motor switches off. Thermal overload? What can I do?
    Also when I did this, the first time I connected the breaker, zone 2 came on by itself for about thirty...
  3. Replies
    25
    Views
    2,747

    Hi, thanks will take a look after work and post a...

    Hi, thanks will take a look after work and post a update.
  4. Replies
    25
    Views
    2,747

    Pump Problem

    Hi, found out the bladder tank was leaking after a week and so the pump would run longer causing the water to heat up. I returned that pump and replaced it with a Berkley (Sta-Rite) HNE jet pump 1HP...
  5. Replies
    25
    Views
    2,747

    Hi, thanks, yes it is less than a month old and I...

    Hi, thanks, yes it is less than a month old and I am thinking of taking it back and getting a cast iron one. The sta-rite one did do the same thing a month ago however the threads on the pump were...
  6. Replies
    25
    Views
    2,747

    The pump shuts off after priming, the problem...

    The pump shuts off after priming, the problem occurs somewhere after zone 3 because I kept checking the pump on and off during zone 1,2 and 3. Everything looked good so I did not check 4,5and 6.
  7. Replies
    25
    Views
    2,747

    Thanks all for your help so far. If a valve is...

    Thanks all for your help so far. If a valve is defective and does not open during a cycle, would not the pressure switch turn the motor off since there no flow out from the motor??
  8. Replies
    25
    Views
    2,747

    The pump is not running dry. Just confused as to...

    The pump is not running dry. Just confused as to why this would happen? The old pump was cast iron and this is thermoplastic and the instructions say to use plastic fittings.
  9. Replies
    25
    Views
    2,747

    hi, it is surface.

    hi, it is surface.
  10. Replies
    25
    Views
    2,747

    Pump Problems

    Hi, I had a 1.5hp Starite pump and I replaced it with a Simer 1.5hp pump. After a couple of days the discharge pipe come completely off from the threading to the pump. The pump or the pipes have no...
Results 1 to 10 of 10