(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Jacob Robinson; Keyword(s):

Search: Search took 0.13 seconds.

  1. Replies
    31
    Views
    8,147

    So if there is continuity between the neutral...

    So if there is continuity between the neutral terminal and the chassis ground, then I DO NOT need to add a jumper. Is this correct?
  2. Replies
    31
    Views
    8,147

    4 wire range to 3 wire receptacle

    I just got a hand me down Maytag range from a co-worker, model MER5765RAS. It came with a 4-wire cord, so I assume I can just wire the 3-wire cord from my old range to the new Maytag, with that said...
  3. Replies
    15
    Views
    1,978

    I ended up getting some Oatey No. 95 Tinning...

    I ended up getting some Oatey No. 95 Tinning Flux, IT MADE ALL THE DIFFERENCE, I soldered up about 25 fittings in the Hot/Cold run and hot not one bad joint. Maybe if I did it more oftern I could...
  4. Replies
    15
    Views
    1,978

    I haven't had a chance to go back and give it...

    I haven't had a chance to go back and give it another whirl, but I was thinking that I would get some Oatey No. 95 tinning flux. The website says it will never burn out (I'm sure this is a relative...
  5. Replies
    15
    Views
    1,978

    All joints were fitted prior to any cleaning or...

    All joints were fitted prior to any cleaning or fluxing.



    This is all brand new work except where I will tie into the old line. (hasn't been done yet, I was planning for that to be last...
  6. Replies
    15
    Views
    1,978

    Soldering Troubles!!

    Tonight I was helping a friend add some plumbing to his basement that he is finishing, we dry fitted all pipes, and I started to solder some of them, it is not often that I sweat pipes but have never...
  7. Replies
    4
    Views
    539

    It is copper, and it is not valved off from the...

    It is copper, and it is not valved off from the rest of the house, where i am tying into the rest of the house will eventually be covered with drywall so I did not want to put a valve on then close...
  8. Replies
    4
    Views
    539

    Testing a New Bath in the Basment

    I have added a new bathroom in the basement I am finishing and I was wondering when testing for leaks in the supply lines is it just as effective to do by turning water on, or should I take the time...
  9. Replies
    11
    Views
    4,968

    Crossover never crossed my mind, in this...

    Crossover never crossed my mind, in this situation there is no good place for shut-offs, as I do not want enclose valves within the wall. I guess I should trade the one I got with one with...
  10. Replies
    11
    Views
    4,968

    Shower Rough-In

    This is my fisrt post although I have been reading for reference on here for a while, Great Site!

    My question is: I am helping a friend add a bathroom in his basement and I have a couple things to...
Results 1 to 10 of 10