(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: musicis; Keyword(s):

Search: Search took 0.12 seconds.

  1. Carrier 58RAV Error 12 "blower on after start up"

    I have a "blower on after startup (115v or 24v)" error 12 going on. Came home to 55 degrees with cold air blowing. When I shut down the power for 15 minutes and restart. The unit right away starts...
  2. Replies
    2
    Views
    1,185

    New water heater install

    Looking for recommendations on water supply hookups. I see my existing water heater was not installed with a 6 inch heat trap. Should I install a few more 90 degree fittings and make a 6 inch heat...
  3. Replies
    13
    Views
    4,675

    I shut down the main today at 9:00 am. I opened...

    I shut down the main today at 9:00 am. I opened every valve in the house. It took an hour for the water to finally stop. It is a huge mansion type house. All was well after that. Thanks to all for...
  4. I thought that if there was a vent "close" to...

    I thought that if there was a vent "close" to where you do an update that you do not have to vent, just trap.
  5. I went to this site because I was concerned. Good...

    I went to this site because I was concerned. Good thing I had the smarts to come here first and confirm my worries. Thanks to all of you for posting your replies. Happy New Year!!!:)
  6. Trapped???? I understand vented. This is all done...

    Trapped???? I understand vented. This is all done I assume.

    I have to think I am better off not doing this upgrade. A new house no problem. But this was built 40 years ago and to spend this time...
  7. Installing washer machine outlet to the wall.

    This building is 40 years old. The utility sink waste is 1 1/2 PVC in the wall. Would there be a problem installing a recessed outlet five feet above the ground that takes 2' PVC and adapting it to...
  8. Replies
    13
    Views
    4,675

    Sweating copper pipe problem

    Finish basement at utility sink. After cutting off the copper hot/cold supply, I still get just enough water to wet the sanded copper I am trying to sweat. I opened up all the valves on the first and...
Results 1 to 8 of 8