Search:

We remodeled the bathroom, but mostly cosmetic changes. New shower fixtures. I don't remember it being as bad before, but I wasn't paying as much attention as it was not a concern as I knew we were...

Thanks for the replies. The end of the duct in the attic is about 1 inch from a roof vent, so the moisture isn't just staying in the attic.

The fan has a built in damper but I have never checked...

It's an old house with no insulation in the walls, and just a few inches in the attic above the bathroom. I doubt it is too airtight. The bathroom door is usually closed or almost closed when the...

I have an 80 sqft bathroom and recently installed a 110 cfm Panasonic bath fan. If the furnace or AC is on, everything is fine. If not, moisture accumulates all over the ceiling, walls, the light,...

Thanks- that is what I hoped. While I'd love to bring everything up to code, it just isn't feasible to add an overflow if the plumbing isn't already available. The new valve is anti scald and...

The tub is not coming out. The setup currently functions, so I don't really understand why replacing the valve and spout is going to turn into a total gut job. Worst case we'll leave the existing...

I guess we'll see what is behind the tile when it comes down. I am curious now. If there is an overflow hopefully it can be connected to the hole in the tub where the spout is now.

There is a rubber stopper for the drain to keep water in the tub. I have been in other houses in the neighborhood that have a similar set up, so doesn't seem too uncommon here.

Interesting. The drain end of the tub is the exterior wall. I guess I can't be certain but I don't think that is the set up with my tub. I do not think there is any overflow.

I guess...

Thanks for the reply. I'm not sure I understand exactly what you are describing. The house was built in the 1920s. The current tub faucet is three handle, with the center knob the diverter. ...

I am remodeling my tub area and the tub spout is currently located where the overflow would normally be. This end of the tub is an exterior wall. The faucet is in the wall on the long side of the...

Does anyone have experience with this Hansgrohe faucet? I am concerned with the 45 degree angle combined with the height of the spout that it might hit the side of the bowl and splash. I plan to...

I have an old bathtub with the tub spout mounted inside the tub where an overflow would normally be. I would like to replace it with something that doesn't stick out into the tub as far. It appears...