Search:

Dear Friends,
Just purchased and installed a Rheem RHG PRO50-40F. Decided to go with a conventional unit that has a pretty good reputation - even made in Alabama by an Alabama Company. So far...

Our second-hand home's builder set the 4 toilet flanges to accommodate a 5/8- inch ceramic/marble tile floors. Evidently the original owners experienced some cost overruns and decided to cut corners...

The pipe and flange are PVC. I'd like to avoid tearing up the floors however as that's an expensive and time-consuming job. How far above the floor is the flange supposed to project? Flush with the...

Dear Friends, I'll bet this isn't an uncommon problem. When the house I live in was built, the toilet flanges were set into the floor assuming that 1/2 inch tiles were to be used to finish the...

Dear Friends, I'm beginning to think that whoever put the 4 toilets in our 20-year old house took a few short cuts that led to the problems I'm now experiencing. The PVC toilet flanges - about a half...

OK! I'm hoping the 4th time's the charm. The tank attachment bolts now have two sets of washers and I bought a really big Channel Lock (16") to tighten up the flush valve now we'll see what happens!...

So, Redwood, there's supposed to be two nuts and washers on the tank screws... That's not what is shown on the installation instructions nor are there extra nuts and washers with the install kit....

At long last I have bitten the bullet and started replacing my old toilets with some nice Toto Drakes. The first installation went along swimmingly and all was working well until I noticed a drips on...